Dayton DTA-1W User Manual

Thank you for purchasing the Dayton Audio DTA-1W

Wireless Class T Amplifier System. This system offers a new
level of high fidelity performance and versatility previously
unattainable with traditional audio amplifiers.

Dayton Audio cuts the cord holding your stereo system
back with the DTA-1W wireless amplifier system. Built upon
the tried-and-true Class T amplifier design, this system exhibits
the same high-fidelity audio quality that audiophiles have come
to love while remaining compact. True stereo sound is sent
from the DTA-1T transmitter unit to the DTA-1AR
amplifier/receiver via 2.4 GHz while maintaining 20-20,000 Hz
(-3 dB) frequency response.

Dayton Audio's DTA-1W is the amplifier solution for
streaming audio outdoors, wireless rear channel surround
speakers, and quickly adding a zone to your stereo system.

Features:

Key features of the DTA-1W include an amplifier
efficiency of up to 88% for long life when powered off batteries
and cool operation, compact sized transmitter and amplifier/
receiver that looks great on desks, 3.5 mm AUX input for
smartphone or MP3 connectivity, and spring loaded speaker
terminals for quick speaker connection.

Additional DTA-1AR Amplifier/Receivers may be
purchased for use with the DTA-1T allowing you to increase
the size of your wireless system (up to 16 DTA-1ARs).

Wireless Class-T Amplifier System

© 2011 Dayton Audio®

DTA-1W

Dayton Audio® • PO Box 52 • Springboro, Ohio 45066

Specifications:

Power Output: 15 watts RMS x 2 into 4 ohms
Total Harmonic Distortion: 0.04% (9W @ 4 ohms)
Dynamic Range: 90 dB
Frequency Response: 20-20,000 Hz
Input Impedance: 10k Ohms
Transmitting Frequency Range: 2.4 GHz (2400-2480 MHz)
Sample Rate: 44.1 KHz, 16-Bit
*Wireless Range: Up to 20 meters (66 ft.) line-of sight

(range may vary)
Electrical Requirements:

DTA-1AR (amplifier/receiver): 12 VDC, 2A
DTA-1T (transmitter): 9 VDC, 1A

Dimensions: 2" H x 6-1/8" W x 3-3/8" D (both units)
Weight: 2.2 lbs total, 1.1 lbs. each unit

Layout

1. DTA-1AR right speaker output

2. Power supply input (both units)

3. Stereo 3.5 mm audio input (both units)

4. DTA-1AR

5. Power on and volume control (both units)

For wireless use: Connect your source to the 3.5 mm input
on the DTA-1T. Connect your speakers (4 or 8 ohms) to the
DTA-1AR. Connect power included power supplies to the
DTA-1T and DTA-1AR. Turn both units on. The DTA-1T will
indicate power on with a blue LED, while the DTA-1AR will
indicate power on and wireless sync to the DTA-1T with a
green LED.

For wired use: Connect a local source is to the AUX input of
the DTA-1AR, the green LED will change from green to blue
and the local source will automatically override the wireless
connection.

Either volume control on the DTA-1T or DTA-1AR may be
used to control the volume level of the amplifier output.