Dayton DSS6-BK User Manual

Inside

Outside

Speaker Spike

Installation

1. Drill four 5/16” diameter holes. Position the holes
approximately 1-1/2” from the corners. (See g. 1)

2. Install barbed inserts

NOTE: The barbed inserts can be installed from

either the inside or outside of the cabinet.

A) Set barbed insert in the hole and nger tighten.

Use a 6 mm hex wrench (not included) to tighten
barbed insert until it is snug. (See g. 2)

Cabinet

(Fig. 1)

(Fig. 2)

Cabinet

(Fig. 1)

(Fig. 2)

B) Repeat procedure for the other pre-drilled holes.

3. Install spikes

A) Thread the threaded stud into the hole, leaving
approximately 5/16” protruding above the
surface. (See g. 3)

B) Remove the tip of the spike and hand tighten
the cone foot on the threaded stud until it is

snug against the bottom of the cabinet.

NOTE: If the threaded stud starts to turn with the

foot, use a screwdriver (not included) to hold it in
place while hand tightening the foot. (See g. 4)

C) Re-install the tip on the cone foot and repeat this

procedure for the other feet.

D) Squeeze a small amount of silicon sealant “RTV”

into each hole to help provide a good seal after
the spike is installed.

(Fig. 3)

(Fig. 3)

E) Repeat procedure for the other spikes.

daytonaudio.com

(Fig. 4)

(Fig. 4)