Daystar KU70039BK User Manual

KU70039 WINCH ISOLATOR

Part No. Description Qty

KU70039 Winch Isolator 1

Bill of Materials

INSTRUCTIONS

1. Switch winch to Free Spool and remove cable from
winch

2. Slide cable through slot on winch isolator, ensuring
isolator is facing direction indicated in picture.

3. Attach the winch cable to the drum and load cable as explained by the
manufacturer’s owners manual. DO NOT allow cable to pull through the isolator.

4. Using the winch safety strap snug the winch hook into the isolator.

www.DaystarWeb.com

Tech Support Contact Info

[e-mail]

Phone: [phone]

Fax: [phone]

841 South 71

Phoenix, AZ 85043

st

Avenue

5. Isolator is designed to rest between the rollers. It does not attach to them.

WARRANTY NOTE

DO NOT USE THE ISOLATOR AS A WINCH GUIDE

WARNING

This vehicle has been modified to enhance its performance. The steering, braking and handling
of this vehicle will differ from standard passenger cars and trucks; this vehicle handles differently
from an ordinary vehicle in driving conditions which may occur on streets, highways and off road.

Avoid unnecessary abrupt maneuvers, sud den stops, sharp turns and other driving conditions
that could cause loss of control, possibly leading to a roll over or oth er accident that coul d result in
serious injury or death to driver and passengers.

If larger tires are installed the speedometer will read lower than the vehicles actual speed.

DRIVE WITH CARE, REDUCE SPEED AND WEAR SEAT BELTS AT ALL TIMES.

This kit should be installed by a professional mechanic.

Instruction Sheet P11163-00

© 2006 Daystar Products International Inc.