Page 1
KT09116
Toyota Tacoma 05-08 / 4-Runner 03-08
Easy install front
4wd & 2wd 6 lug only
www.DaystarWeb.com
Tech Support Contact Info
Tech@DaystarWeb.com
Phone: 623.907.0081
Fax: 623.907.0088
841 South 71
Phoenix, AZ 85043
st
Avenue
Instruction Sheet P10668-03
2008 Daystar Products International Inc.
1 of 3 pages
Page 2
1. Read all instructions and check bill of materials and tools before beginning.
2. Disconnect the negative battery cable.
3. Place the vehicle on a clean and level surface. Set the parking brake and
place wheel chocks behind the rear wheels. Jack up the front of the vehicle
by the frame with a floor jack and support vehicle at the frame rails with approved jack stands. NEVER WORK UNDER AN UNSUPPORTED VE-
HICLE.
4. Disconnect the ABS and brake lines from the upper a-arm and spindle
( 10mm and 12mm bolts.
5. Disconnect the sway bar on both side at the spindle. ( 17mm bolt. )
Installation Steps
6. Remove the upper strut nuts.( 14mm nuts ) You will need to reuse them later.
7. Remove upper ball joint nut ( 19mm nut ) and separate the ball joint from the
spindle by hitting the side of the spindle. DO NOT use a ball joint separator
tool it can damage the ball joint boot.
Instruction Sheet P10668-01
2008 Daystar Products Intl
Page 2 of 3
Page 3
Installation Steps
8. Remove the lower strut bolt and nut ( 19mm) .
9. Remove the strut from the vehicle.
10. Install the stud extenders and spacer on the top of the strut plate.
11. Reinstall the strut into the vehicle and tighten the upper strut nuts. You will have
to push up on the upper a-arm to get the strut back in.
12. Reinstall the suspension working in reverse order.
13. Recheck all bolts after 500 miles.
14. Daystar Recommends that you have your wheel alignment checked.
TOOLS NEEDED
1. Floor Jack
2. Jack stands
3. Wheel chocks
4. Set of metric tools from
10mm to 19mm
5. Hammer
Bill of Materials
Part No. Description Qty
M03724 Spacer 2
S11057 Stud ext 6
P11131 Instructions
Instruction Sheet P10668-01
2008 Daystar Products Intl
Page 3 of 3
Loading...