Daystar KN09106BK User Manual

KN09106 – 2005-UP Nissan Xterra/Frontier 2” Front Leveling Kit

www.DaystarWeb.com

Tech Support: [e-mail]

Phone: [phone] / Fax: [phone]

841 South 71

st

Avenue; Phoenix, AZ 85043

Tools required

Description:

Standard sockets, hand tools Etc.

Hydraulic Lift is Recommended

Floor Jacks / Jack Stands

Ball joint separator

Part # Description Qty

S11013 STRUT SPACER (FRONT) 2
S10203 7/16-14 NYLOCK NUTS (FRONT) 6
S11016 7/16 SAE NARROW WASHER (FRONT) 6

Bill of Materials

INSTALLATION INSTRUCTIONS

1. Read instructions completely, verify bill of materials and determine if you have the correct tools
before beginning installation.

Front Installation

2. Raise vehicle until front tires are clear, support the vehicle.

3. Remove the front tire and wheel assembly.

4. Remove the lower stabilizer link bolt and move sway-bar assembly
out of way.

5. Remove the upper ball joint nut.

6. Separate the upper ball joint from the spindle.

7. Remove the strut assembly and install the strut spacer see Fig. 1.

8. Rotate the strut (with spacer installed) 180 º.

Reassemble spindle and ball joint

WARNING

This vehicle has been modified to enhance its performance.
The steering, braking and handling of this vehicle will differ
from standard passenger cars and trucks. This vehicle
handles differently from an ordinary vehicle in driving
conditions which may occur on streets, highways and off road.
Avoid unnecessary abrupt maneuvers, sudden stops, sharp
turns and other driving conditions that could cause loss of
control, possibly leading to a roll over or other accident that
could result in serious injury or death to driver and passengers.
If larger tires are installed the speedometer will read lower than
the vehicles actual speed.

DRIVE WITH CARE, REDUCE SPEED

AND WEAR SEAT BELTS AT ALL TIMES.

This kit should be installed by a professional mechanic.

© 2005 Daystar Products International Inc.

Fig 1. OE STRUT WITH SPACER ON TOP

Instruction Sheet - P11079-00

Page 1 of 1