Daystar KJ09127BK User Manual

TOOLS NEEDED

BILL OF MATERIALS

• FLOOR JACK

• 2 JACK STANDS 2 TON

• 2 WHEEL CHOCKS

• DRILL + 5/16-1132 DRILL BIT

• SPRING COMPRESSOR

• STANDARD HAND TOOLS

PART# DESCRIPTION QTY
M03606
M02533

M03194
S10210
S10921

FT SPACER 2
FT BUMP STOP 2
FT BUMP STOP 2

REAR SHACKLE 2

FT TRACK BAR

MOUNT

BU79097

HARDWARE KIT 1

KJ09127

1984 TO 2001 JEEP CHEROKEE XJ

2WD & 4WD

1

3” LIFT KIT

www.Daystaproducts.com

Tech Support Contact Info

[e-mail]

Phone: [phone]

Fax: [phone]

841 South 71

st

Avenue

Instruction Sheet P11282-00
2007 Daystar Products International Inc.

Thank you for choosing Daystar Products

Daystar recommends a certified technician install this system . In addition to
these instructions , professional knowledge of disassemble/reassembly proce­dures as well as post instructions checks must be known. Attempts to install this
system without this knowledge and expertise may jeopardize the integrity and/or
operating of the vehicle.

Please read all the instructions before beginning the installation. Check the kit
hardware against the parts list. Be sure you have all the needed parts and under­stand where they go. If anything is missing , do not proceed with the installa­tion, call Daystar Products to obtain needed items.

Other Jeep Cherokee products.

• KJ01009 1” inch transfer case drop

• KJ03002 Front control arm bushing kit

• KJ02008 Rear spring bushing kit

• KU70083 Upper adjustable control arm kit

• KU70084 Lower adjustable control arm kit

• KJ70028 Front winch bumper w/o skid plate

• KJ70034 Rear bumper

• KJ70035 Rock Rails w/o side plates

More product at www.Daystarproducts.com

Product Use Information

As a general rule, the taller a vehicle is the easier it will roll. We strongly recom­mend , because of rollover possibility, that seat belts and shoulder harness be
worn at all times. Avoid situations where a side rollover may occur.

Braking performance and capabilities are decreased when significantly large/
heavier tires and wheels are used. Take this into consideration while driving,
Also , speedometer recalibration is necessary when larger tires are installed.

Do not add, alter, or fabricate any factory or after-market pa rt s whi ch inc rease
vehicle height over the intended height of the Daystar Product purchased. Mixing
component brands, lifts, and/or combining body lift with suspension lift voids all
warranties. Daystar makes no claims regarding lifting devices and excludes any
and all implied claims. We will not be responsible for any products that are al­tered.

Notice to Dealer and Vehicle Owner

Any vehicle equipped with any Daystar Product must have the “Warning to
driver” decal installed on the sun visor or dash. The decal is to act a constant re­minder for whoever is operating the vehicle of its uniq ue h andl i n g characteristics.
INSTALLING DEALER— Its is your responsibility to install the warning decal
and forward these instructions on to the vehicle owner for review and to be kept
in the vehicle for service life.

After installation occurs, a qualified alignment facility is required to align the
vehicle to factory specs.

Upper control arms

Lower control arms

Rear Bumper