Daystar KJ09118BK User Manual

www.DaystarWeb.com

Tech Support Contact Info

[e-mail]

Phone: [phone]

Fax: [phone]

Avenue

Phoenix, AZ 85043

Instruction Sheet P10537

-

00

.

Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 5

WARNING

hance its performance. The steering, braking and handling

of this vehicle will differ from standard passenger cars and trucks, This vehicle handles differently

Avoid unnecessary abrupt maneuvers, sudden stops, sharp turns and other driving conditions

that could cause loss of control, possibly leading to a roll over or other accident that could result in

Jeep KJ Liberty 2” Rear Coil Spring Spacers

Part No. Description Qty
M03324 Coil Spacer R 2
M00337 Shock Boot R 2
P01055 Cable Ties 2

NOTE: SEE WARNING AT BOTTOM
OF PAGE.

Rear Installation Instructions

1. Raise the rear of vehicle and support with jack stands in front of the lower control
arms so that the rear tires are off of the ground. Remove the rear wheels.

2. With a floor jack supporting the axle, disconnect the upper shock mounts. Figure 1.

3. Lower the axle and remove the coil springs. Figure 2.

4. Remove the lower coil spring isolator. Figure 3.

5. Install the coil spring spacer in the same position as the lower isolator. Figure 4.

6. Install the coil spring on top of the coil spring spacer. (You may have to use a coil
spring compressor to reinstall the coil spring) Figure 5.

7. Raise the floor jack and reconnect the upper shock mounts and torque all bolts to
factory specs.

8. Reinstall the wheels and lower the vehicle to the ground.

9. Recheck all bolts after 500 miles.

10. Upon completion of kit installation the following warning applies :

This vehicle has been modified to en

from an ordinary vehicle in driving conditions which may occur on streets, highways and off road.

Bill of Materials

841 South 71

st

serious injury or death to driver and passengers.

If larger tires are installed the speedometer will read lower than the vehicles actual speed.

DRIVE WITH CARE, REDUCE SPEED AND WEAR SEAT BELTS AT ALL TIMES.

This kit should be installed by a professional mechanic

 2000 Daystar Products International Inc