Page 1
www.DaystarWeb.com
Tech Support Contact Info
KJ04504 81-86 CJ-8 1” Body Lift Installation Instructions
Before beginning read all instructions and check Bill of Materials
Part No. Description Qty
M02285 Bushing 1
M02287 Bushing 12
M02787 Bushing 12
M02905 Bushing 1
S10104 Washer 3/8 20
S10349 Bolt 3/8-16x3.5” Hex 12
Bill Of Material
S10350* Bolt 7/16-14x3.5” Hex 3
S10276 Steel Sleeve 12
S10012 Steel Sleeve 1
S10385* Washer 7/16 6
*Location 6 may use 7/16-14x3.5” bolts. Check the stock body bolts
too determine which replacement bolts are to be used for your
application.
Tech@DaystarWeb.com
Phone: 623.907.0081
Fax: 623.907.0088
841 South 71st Avenue
Phoenix, AZ 85043
1. PLASTIC RADIATOR FAN SHROUD: Only raise body high enough to remove and replace body mounts. Always
watch the fan shroud for sufficient clearance when raising the body.
2. Loosen body mount bolts on one side of vehicle and remove bolts from opposite side for positions 1,5 and 6 (ref.
Fig.1) and positions 2, 3 and 4. Use a long extension to remove mounts next to gas tank. Place 2x4 between jack
and body to spread out load and jack up body on the side you have removed the bolts from just far enough to
remove mounts. The bolts on the opposite side will help ensure that the body does not shift. CAUTION: Open
Hood while jacking up the body to make sure that the fan doesn’t hit the shroud. Also, watch that hoses and wires
are not stretched. When lifting the side of the vehicle that the fuel filler is on keep a close eye not to stretch, tear
or pull too far on the hose connection.
3. Remove factory mounts one at a time and insert the corresponding steel sleeves into the new body mounts.
4. Jack up the body using a 2x4 under one side of the body for support just high enough to insert new body lift
spacers. If the steel collar on new mounts will not insert in frame holes, you may have to file out frame mount hole
slightly to install spacer. Repeat on opposite side.
5. Now remove bolts from other side of vehicle and repeat instructions 2 through 4.
6. Once all new mounts are in place, you may re-torque all bolts to factory specs. Do not over tighten bolts.
7. Before starting engine, check fan for clearance of all lines and wires to make sure they are free and clear.
POSITION 1
BODY
M02905
STEEL SLEEVE
S10012
FRAME
M02285
WASHER
BOLT
BODY
WASHER
M02787
STEEL SLEEVE
S10276
POSITION 2 POSITION 3,4,5,6 & 7
FRAME
M02287
WASHER
BOLT
BODY
WASHER
M02787
STEEL SLEEVE
S10276
FRAME
M02287
WASHER
BOLT
Instruction Sheet P10444-06
2002 Daystar Products International
Loading...