Daystar KJ03007BK User Manual
www.DaystarWeb.com
Tech Support Contact Info
Tech@DaystarWeb.com
Phone: 623.907.0081
0088
Avenue
Phoenix, AZ 85043
Instruction Sheet P10521
-
00
Inc.
KJ03007 Jeep TJ Rear Control Arm Bushing Kit 1997-2001
Part No.
M02413
M02409
M02414
M02411
S10091 Steel Sleeve 4
S10092 Steel Sleeve 4
A01133 Daystar Lubrethane 1
Bill Of Materials
Description Qty.
Bushing 4
Thrust Washer 4
Bushing 4
Thrust Washer 4
Fax: 623.907.
841 South 71
Installation Instructions
1. Please read the instructions completely and check the Bill of Material before beginning the installation.
2. Raise and support the vehicle with jack stands in front of the rear leaf spring perches so that the tires
just touch the ground.
3. Remove one control arm at a time noting its position and how it is installed. On the upper control arms
you will have to remove the E-brake cables.
4. Remove the factory rubber bushings by burning out the centers with a suitable propane or acetylene
torch. DO NOT damage the outer shells, as they will be reused.
5. Clean the outer shells with a suitable tool so that they are free and clear of any debris.
6. Using the supplied Daystar Lubrethane, install the corresponding bushing, thrust washer, and steel
sleeve into the control arm sleeve per the figures below.
7. Reinstall the control arm from the position in which it was removed and torque to factory specifications.
8. Complete this for the other three control arms.
9. Recheck all bolts and re-torque after 500 miles.
st
2000 Daystar Products International
Loading...