Page 1
www.DaystarWeb.com
Tech Support Contact Info
KJ03003 Jeep ZJ Front Control Arm Bushing Kit 1993-1998
Part No. Description Qty.
M02409 Thrust Washer 2
M02413 Bushing 2
M02411 Thrust Washer 4
M02414 Bushing 4
M02422 Bushing 2
M02428 Thrust Washer 2
S10091 Steel Sleeve 2
S10092 Steel Sleeve 4
S10100 Steel Sleeve 2
A01133 Daystar Lubrathane 1
Bill of Materials
Tech@DaystarWeb.com
Phone: 623.907.0081
Fax: 623.907.0088
841 South 71
Phoenix, AZ 85043
st
Installation Instructions
1. Read all instructions completely and check the Bill of Materials before beginning the installation.
2. Raise and support the front of the vehicle with jack stands behind the rear leaf spring perches so that the tires just
touch the ground.
3. Remove one control arm at a time noting its position and how it is installed.
4. Remove the factory rubber bushings by burning out the centers with a suitable propane or acetylene torch. DO
NOT damages the outer shells, as they will be reused.
5. Clean the outer shells with a suitable tool so that they are free and clear of any debris.
6. Using the supplied Daystar Lubrathane, install the corresponding bushing, thrust washer, and steel sleeve into the
control arm sleeve per the figures below.
7. Reinstall the control arm into the position from which it was removed and torque to factory specifications.
8. Repeat this for the other three control arms.
9. Recheck all bolts and re-torque after 500 miles.
This vehicle has been modified to enhance its performance. T he steering, braking and handling of this vehicle will differ from
standard passenger cars and trucks, This vehicle handles differently from an ordinary vehicle in dri ving conditions which may
occur on streets, highways and off road. Avoid unnecessary abrupt maneuvers, sudden stops, sharp turns and other driving
conditions that could cause loss of control, possibl y leading to a roll over or other accident that could result in ser ious injury or
death to driver and passengers. If larger tires are installed the speedometer will read lower than the vehicle’s actual speed.
DRIVE WITH CARE, REDUCE SPEED AND WEAR SEAT BELTS AT ALL TIMES
This kit should be installed by a professional mechanic.
WARNING
.
Instruction Sheet P10230-01
© 2000 Daystar Products International Inc.
Avenue
Loading...