Page 1
www.DaystarWeb.com
Tech Support Contact Info
KJ03004 Jeep ZJ Rear Control Arm Bushing Kit 1993-1998
Part No. Description Qty.
M02409 Thrust Washer 4
M02411 Thrust Washer 4
M02413 Bushing 4
M02414 Bushing 4
S10091 Steel Sleeve 4
S10092 Steel Sleeve 4
A01133 Daystar Lubrathane 1
Bill Of Materials
Tech@DaystarWeb.com
Phone: 623.907.0081
Fax: 623.907.0088
841 South 71
Phoenix, AZ 85043
st
Avenue
Installation Instructions
1. Read all instructions completely and check the Bill of Materials before beginning the installation.
2. Raise and support the vehicle with jack stands in front of the rear leaf spring perches so that the tires just touch
the ground.
3. Remove one control arm at a time noting its position and how it is installed. On the upper control arms you will
have to remove the E-brake cables.
4. Remove the factory rubber bushings by burning out the centers with a suitable propane or acetylene torch. DO
NOT damage the outer shells, as they will be reused.
5. Clean the outer shells with a suitable tool so that they are free and clear of any debris.
6. Using the supplied Daystar Lubrathane, install the corresponding bushing, thrust washer, and steel sleeve into the
control arm sleeve per the figures below.
7. Reinstall the control arm into the position from which it was removed and torque to factory specifications.
8. Repeat this for the other three control arms.
9. Recheck all bolts and re-torque after 500 miles.
This vehicle has been modified to enhance its performance. The steering, braking and handling of this vehicle will differ from
standard passenger cars and trucks, This vehicle handles d ifferently from an or dinary vehicle in driving cond itions which may occur
on streets, highways and off road. Avoid unnecessary abr upt maneuvers, sudden stops, sharp turns and other driving con ditions
that could cause loss of control, possibly leading to a roll over or oth er accident that could result in serious inj ury or death to driver
and passengers. If larger tires are installed the speedometer will read lower than the vehicle’s actual speed.
DRIVE WITH CARE, REDUCE SPEED AND WEAR SEAT BELTS AT ALL TIMES.
This kit should be installed by a professional mechanic.
WARNING
Instruction Sheet P10532-00
© 2000 Daystar Products International Inc.
Loading...