Page 1
KF09119 Ford 2005 -08 4WD Super Duty
Front Coil Spring Spacer Lift Kit
Part No. Description Qty
M03634 Coil Spring Spacer 2
Bill of Materials
www.DaystarWeb.com
Tech Support Contact Info
Tech@DaystarWeb.com
Phone: 623.907.0081
Fax: 623.907.0088
841 South 71
Phoenix, AZ 85043
st
Avenue
Wrench set & Socket set 1
Coil Spring Compressor 2
Floor Jacks / Jack Stands 2/4
Additional Hardware Needed
Description: Qty.
New Shock Absorbers
Daystar shock
KU01001
Tools required
Description: Qty.
2
Step(s)
1. Layout all parts and check quantities against the Bill of Materials. Completely
2. Make sure you are working on a level, stable concrete surface or using a lift to
3. Jack the front of the vehicle in accordance to manufacturer recommendation
4. Remove front wheels.
5. Raise the axle using the floor jacks enough to relieve tension in the shocks.
6. Disconnect endlinks to sway bar, brake line bracket and OE shocks
7. Lower the front axle as far as possible. Remove only one spring
8. Compress spring down, install new isolator (M03634) and reinstall
9. Repeat steps 7 and 8 for other side.
10. Lift axle back up and install new shocks, brake line bracket (Fig.3)
11. Put wheels back on (torque to manufacture’s spec.) and lower
( DO NOT COMBINE WITH ANY OTHER SUSPENSION KIT )
read instructions before beginning installation.
perform this work.
and support vehicle with jack stands, use the floor jacks to support the axle so
it can be lifted and lowered relative to the vehicle.
(both sides). Fig.1
(mark or note spring orientation before removal). Remove OE spring
isolator.
spring.
and reconnect sway bar endlinks.
vehicle to ground.
Fig. 1
Fig. 2
Instruction Sheet P10861-01
Page
1 of 2
© 2004 Daystar Products International Inc.
Page 2
KF09119 Ford 2005 -08 4WD Super Duty
Front Coil Spring Spacer Lift Kit
Fig. 3
www.DaystarWeb.com
Tech Support Contact Info
Tech@DaystarWeb.com
Phone: 623.907.0081
Fax: 623.907.0088
841 South 71
Phoenix, AZ 85043
st
Avenue
WARNING
This vehicle has been modified to enhance its performance.
The steering, braking and handling of this vehicle will differ
from standard passenger cars and trucks; this vehicle handles
differently from an ordinary vehicle in driving conditions which
may occur on streets, highways and off road.
Avoid unnecessary abrupt maneuvers, sudden stops, sharp
turns and other driving conditions that could cause loss of
control, possibly leading to a roll over or other accident that
could result in serious injury or death to driver and passengers.
If larger tires are installed the speedometer will read lower
than the vehicles actual speed.
DRIVE WITH CARE, REDUCE SPEED
AND WEAR SEAT BELTS AT ALL TIMES.
This kit should be installed by a professional mechanic.
Instruction Sheet P10861-01
Page
2 of 2
© 2004 Daystar Products International Inc.
Loading...