Daystar KF09052-1 User Manual

www.DaystarWeb.com

KF09049BK Ford 2005 -12 4WD Super Duty
Front Coil Spring Spacer Lift Kit

Part No.

M03634 Coil Spring Spacer 2

Bill of Materials

Description Qty

Tech Support Contact Info

[e-mail]

Phone: [phone]

Fax: [phone]

841 South 71st Avenue

Phoenix, AZ 85043

Wrench set & Socket set 1

Coil Spring Compressor 2

Floor Jacks / Jack Stands 2/4

Description: Qty.

H7091S Front Shock 2

H7073S Rear Shock 2

BU01001 Front Shock

hardware bag

BU01016 Rear Shock

Hardware Bag

Step(s)

1. Layout all parts and check quantities against the Bill of Materials. Completely

2. Make sure you are working on a level, stable concrete surface or using a lift to

3. Jack up the front of the vehicle in accordance to manufacturer recommendation

4. Remove front wheels.

5. Raise the axle using the floor jacks enough to relieve tension in the

6. Disconnect end links to sway bar, brake line bracket and OE shocks

7. Lower the front axle as far as possible. Remove only one spring

8. Compress spring down, install new isolator (M03634) and reinstall

9. Repeat steps 7 and 8 for other side.

10. Lift axle back up and install the brake line bracket (Fig.3) and

Tools required

Description: Qty.

Shock Absorbers

1

1

(DO NOT COMBINE WITH ANY OTHER SUSPENSION KIT)

read instructions before beginning installation.

perform this work.

and support vehicle with jack stands, use the floor jacks to support the axle so
it can be lifted and lowered relative to the vehicle.

shocks.

(both sides). Fig.1

(mark or note spring orientation before removal). Remove OE spring
isolator.

spring.

reconnect sway bar end links.

Fig. 1

Fig. 2

Instruction Sheet P20448

Page

1 of 2

 2004 Daystar Products International Inc.

www.DaystarWeb.com

KF09049BK Ford 2005 -12 4WD Super Duty
Front Coil Spring Spacer Lift Kit

11. Assemble the bushings, sleeves, and shock boots for the front
shocks. Install them using the factory hardware.

12. Put wheels back on (torque to manufacture’s spec.) and lower
vehicle to ground.

13. In the rear, remove the factory shock absorbers.

14. Install the bushings, sleeves, and shock boots on the supplied shock
absorbers. Install the shocks on the vehicle using the factory
hardware.

Tech Support Contact Info

[e-mail]

Phone: [phone]

Fax: [phone]

841 South 71st Avenue

Phoenix, AZ 85043

Fig. 3

WARNING

This vehicle has been modified to enhance its performance.
The steering, braking and handling of this vehicle will differ
from standard passenger cars and trucks; this vehicle handles
differently from an ordinary vehicle in driving conditions which
may occur on streets, highways and off road.

Avoid unnecessary abrupt maneuvers, sudden stops, sharp
turns and other driving conditions that could cause loss of
control, possibly leading to a roll over or other accident that
could result in serious injury or death to driver and passengers.

If larger tires are installed the speedometer will read lower
than the vehicles actual speed.

DRIVE WITH CARE, REDUCE SPEED

AND WEAR SEAT BELTS AT ALL TIMES.

This kit should be installed by a professional mechanic.

 2004 Daystar Products International Inc.

Instruction Sheet P20448

Page

2 of 2