Dayi Technology MPRC01 User Manual

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for

a Class B digital device, pursuant to Part 15 of the FCC Rules. These

limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates,

uses and can radiate radio frequency energy and, if not installed and

used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation. If

this equipment does cause harmful interference to radio or television

reception, which can be determined by turning the equipment off and

on, the user is encouraged to try to correct the interference by one of

the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

- Consult the dealer or an experienced radio/TV technician for

help.

This device complies with Part 15 of the FCC Rules. Operation is subject

to the following two conditions: (1) This device may not cause harmful

interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

FCC Caution: Any changes or modifications not expressly approved by

the party responsible for compliance could void the user's authority to

operate this equipment.

IMPORTANT NOTE:

FCC Radiation Exposure Statement:

This equipment complies with FCC radiation exposure limits set forth for

an uncontrolled environment.

This transmitter must not be co-located or operating in conjunction with any
other antenna or transmitter.

1

Operation Manual

Operation Manual

Operation ManualOperation Manual

. POWER

1.1 Uses two DC3.6V lithium batteries
(one for knee body, one for remote

controller)
* A fully charged battery, if unused for
a minimum period of one month, will

become flat.
* A new battery has to be charged
before using.

1.2 To charge

*

Lithium battery charger uses
AC110~120V→60HZ, 6W or
AC220~240V→50HZ, 6W

*

The micro IC will indicate the "OFF"

position, when the battery is almost flat,
but the knee joint will still be operational.

*

Charging will cease automatically

when battery is fully charged.

*

With the battery fully charged, the remote

controller will indicate the"ON"position
after the first movement of the knee joint.

。

1.3 Charge time

*

One full charge time takes approximately

5 hours.

*

The signal light will turn red when the
battery is flat and it will turn off when the
battery is fully charged or the battery is
full.

1.4 The charger is especially for the

lithium battery.

2. REMOTE CONT

ROLLER

2.2 The remote controller

2.4 The pow

er consumption of

joint is moving.

2.3Conserve the battery:

2.1 Push button description:
* power (ON/OFF) switch.
* Auto ON/OFF.:

"ON "fully automatic
"OFF "non automatic

* Gait(+, - )”OFF " non

automatic;
the gait speed can be adjusted

by pushing the + ,- button.

calculates the speed and
category level after the first
movement of the knee joint. If
it is in the "ON" position, the
IC will adjust automatically
without any further

* The remote controller will shut

off when the knee is not in
motion for over 3 min.

* The knee joint drive will shut off

when the knee is not in motion
for over 30 seconds.

*The effective distance for the

remote controlle is 5 meters 。

the battery can be
detected by the remote
controller when the knee