Product # 7957
C
OUPLER
K
IT
F
OR STANDARD
4-
AND
6-C
ONDUCTOR CABLES
The Coupler Kit is used to connect standard extension cables to standard sensor cables. It includes both a 6-pin cable coupler and waterproof crimp-style
splice connectors for making the connection as well as a protective shell in
which you may place the connection point.
C
OMPONENTS
The Coupler Kit includes the following components. Please make sure you
have all listed components before continuing.
✦
Protective Shell (in two pieces)
✦
6-Pin Cable Coupler
✦
Four #4 x ∫ ” (12.5 mm) Screws
✦
Seven Splice Connectors
✦
One Cable Tie
T
OOLS
AND
M
ATERIALS
N
EEDED
You may need some of the following tools and materials in order to complete
your installation. Please be sure you have everything you need before beginning.
✦
Small Screwdriver
✦
Pliers
✦
Telephone Wire Stripper or Knife
✦
Hose Clamps or Conduit Clamps
✦
Cable Clips or Weather-Resistant Cable Ties
Page 2 Coupler Kit
T
IPS
ON
M
AKING
C
ONNECTIONS
For the best connection, note the following suggestions:
✦
If the connection between the cables will be located outside, we recommend that
you use the splice connectors rather than the coupler.
With the splice connectors, there is less chance of the cables separating
and also less chance of water reaching the connection. Use the cable coupler only if the connection is located inside, protected from the effects of
weather and other stresses.
✦
T ry to place the connection between cables inside a building, underneath an eave,
or in another location similarly shielded from rain.
✦
The protective shell must be well secured to avoid wind buffeting.
Use hose clamps for poles or conduit clamps for surface mount.
✦
When securing cables, place a cable clip or tie on each side of the protective shell
so the movement of the cables does not cause the connection to pull apart.
✦
It is a good practice to leave an extra length of cable near the connection point in
case future adjustments or repairs are necessary.
T
O
C
ONNECT
THE
C
ABLES
U
SING
THE
S
PLICE
C
ONNECTORS
1. Cut the modular connector off the end of the cable.
2. Use a telephone wire stripper or a knife to strip away about 1 ∫ (3.8 cm) inches of the
black shielding on the cable.
Do not strip away any of the colored shielding on the individual wires.
Repeat this procedure for the end of each cable you are connecting.
S
TRIP
S
HIELDING
Loading...