Quick user Guide for Integrity MCC-RF
1) Connect MCC-RF adaptor to mini usb port
Ensure the power is switched ON.
2) Place the Integrity Mobile unit on the cradle for charging.
3) LED indication for charging will light on.
4) Press and hold the push button switch for 10seconds.
This will enable the learning process between Integrity MCC-RF & Integrity Mobile.
After the learning process is success ful, if the button on mobile device is pressed this
Will activate the indication at Integrity MCC-RF via beeping.
Integrity
Mobile
Button on Mobile
device
Integrity
MCC-RF
Federal Communications Commission (FCC) Statement
15.21
You are cautioned that changes or modifications not expressly approved by the part responsible
for compliance could void the user’s authority to operate the equipment.
15.105(b)
This equipment has been tested and found to comply wit h the limits for a Class B digital device,
pursuant to part 15 of the FCC rules. These limits are designed to provide reason able
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or te levision reception, which can be determined b y tur ning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipm ent and rece iver.
-Connect the equipment in to an outlet on a circuit different from that to which the receiver is
connected.
-Consult the dealer or an experie nced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Op eration is subject to the fol l owing
two conditions:
1) this device may not cause harmful interference and
2) this device must accept any interference received , including interference that may cause
undesired operation of the device.
Loading...