DAVIS Anemometer for Vantage Pro2 User Manual
USER
MANUAL
Anemometer
for Vantage Pro2
Product number: 6410
R
Davis Instruments, 3465 Diablo Avenue, Hayward, CA 94545-2778 U.S.A. • 510-732-9229 • www.davisnet.com
Welcome to
Anemometer for Vantage Pro2
The anemometer measures and displays wind speed and direction. The data is used
to calculate other wind-related information such as wind run, wind chill, and the
temperature-humidity-sun-wind index. This anemometer can be used with any
Vantage Pro2-compatible system.
Contents of Package
(6410)
Wind Vane
Wind Cups
Anemometer Arm
with 40 feet (12.2 meters)
of cable
The package contains the following:
• Anemometer arm with 40 feet (12.2 meters) of cable
• Wind vane
• Wind cups
• Anemometer base
Anemometer
Base
1
Hardware Kit
U-Bolt
1/4" Flat Washers
1/4" Lock Washers
1/4" Hex Nuts
.05" Allen
Wrench
1/4" x 3" Lag Screws
#4 x 1-1/8"
Machine Screw
#4 Tooth
Lock Washer
#4-40 Hex Nut
Tools for Setup
• Cable Clips or Weather-Resistant Cable Ties
Note: Make sure the clips or ties you use to secure the anemometer cable have screw holes or other
means for mounting the cable. Do not use metal staples to secure the cables.
• Small Screwdrivers
• Adjustable Wrench
• Hand-Held Compass or Local Area Map
Assemble the Anemometer
Attach the Wind Vane
The wind direction has been calibrated in the factory so that the wind direction
will be correct when the arm is installed pointing north and the vane is installed
correctly.
1. Slide the wind vane onto the wind vane shaft. The shaft’s cross section is Dshaped to ensure that the anemometer is installed correctly.
2. Tighten the set screw in the wind vane with the Allen wrench.
2
Loading...