#1458 Air-Dryr 1000
#1459 Air-Dryr 500
LISTED
GENERAL INFORMATION
Davis’ Air-Dryr is designed to operate 24 hours a day. It is
constructed of U.L. approved polycarbonate plastic.
An aluminum base panel supports the tubular metal heating
element. The product is closed with stainless steel screws.
The Air-Dryr does not have a switch, thermostat, fan, or any
moving parts to break down. It is completely silent during
operation. Cool, damp air is drawn through the bottom base
panel, heated, then released through the top perforated surface.
Two models of Air-Dryr are available for the U.S. market.
Both operate on 110/120 volts:
Air-Dryr 1000 has a 130 watt heating element and is
designed to handle up to 1000 cubic feet of living space.
It draws only 1.1 amps.
Air-Dryr 500 has a 70 watt heating element and handles up
to 500 cubic feet of living space. It draws only 0.6 amps.
Davis also offers two Air-Dryr models with European
Certification, operating on 220 volts: 1458EU and 1459 EU.
See separate instructions for those products.
DIRECTIONS FOR USE
Always operate Air-Dryr in the normal upright position to
gain the proper efficiency. The unit operates best in an
enclosed area not exceeding 1000 cubic feet for Air-Dryr
1000, 500 cubic feet for Air-Dryr 500.
Place Air-Dryr on the floor in the area to be served. Plug
power cord into any standard 110-volt grounded outlet.
When unit is placed on a high pile carpet, airflow through
the bottom intake holes may be restricted. For this reason,
steps should be taken to maintain a clear air space beneath
the unit when it is operating on any surface other than a flat,
hard one.
After you plug in Air-Dryr, allow 15 to 20 minutes for the unit
to heat to proper operating temperature.
Exterior surfaces may be cleaned with a mild detergent and
water solution on a moist cloth when unit is not plugged in
and has been allowed to cool.
ONE-YEAR WARRANTY
We warrant our products to be free of defects in material
and workmanship for one year from the date of original purchase. Write for full warranty details.
IMPORTANT SAFEGUARDS
When using electrical appliances, basic safety precautions should always be followed, including the
following:
1. Read and save all instructions.
2. Do not touch hot surfaces.
3. To protect against electrical shock, do not immerse
cord or main body of Air-Dryr in water or other liquids.
4. Close supervision is necessary when appliance is used
by or near children.
5. Unplug unit from outlet and allow to cool before cleaning or storing.
6. Do not operate any appliance with a damaged cord or
plug, or after the appliance malfunctions or has been
damaged in any manner. DO NOT ATTEMPT TO DIS-
ASSEMBLE. Return unit to Davis Instruments Corp. for
examination, repair, or adjustments.
7. Do not use outdoors.
8. Do not place on or near a hot gas or electric burner or
in an oven.
9. Do not use appliance for other than intended use.
10. Do not attempt to clean exterior when unit is plugged
in. Apply cleaners with a cloth; do not spray on.
To prevent fire or damage to unit, do not block vent
holes. Keep out of water to protect against electrical
shock. Do not touch hot surfaces. Unplug and allow to
cool before cleaning or storing. Do not place on or near
a hot gas or electric burner or in an oven.
Air-Dryr is equipped with a THERMAL CUTOFF to prevent overheating due to blocked vent holes, but CONTINUED CAUTION IS ADVISED.
CAUTION
The Mildew Fighter
3465 Diablo Avenue, Hayward, CA 94545, U.S.A.
Phone (510) 732-9229 • Fax (510) 732-9188
info@davisnet.com
For information about our other fine products,
visit www.davisnet.com
07395.288 Rev. A