Davis 7717 Installation Manual
MOUNTING POLE KIT
INSTALLATION MANUAL
This manual covers use of the Mounting Pole Kit with the Integrated Sensor
TM
Suite (ISS) of the Vantage Pro
system. (The kit can also be used with other
Davis Instruments sensor arrays, applying the principles shown here with the
ISS. On page 4, you may need to use a second U-bolt during step 2 .)
COM PONENTS
The mounting kit includes the following:
Support Tube
(19.5" long, swaged end)
8" Cable Ties
5/16" x 3"
Lag Screws
5/16" Flat Washers
5/16" x 1-1/2"
U-Bolt
1-1/8" Saddle
5/16" Flat Washers
5/16" Lock Washers
5/16" Hex Nuts
1-1/8" Saddles
Extension Tube (21" long)
TOOLS AND MATERIALS NEEDED
In addition to the hardwar e shown above, you may need some of the following
tools and materials:
• Adjustable wrench
• Drill with 1/4" (6 mm) bit
Product # 7717
INS TALLATION STEPS
r
• Secure one side or both sides of your ISS to the support tube, page 2
• Mount the extension tube, page 3
• Install the support tube on the extension tube, page 4
SECU RE THE ISS TO THE SUPPORT TUBE
The support tube is 19-1/2" (0.5 m) long, and has a swaged end. After you
secure one or both sides of your ISS to the support tube, this end will be
inserted into the top of the extension tube. Make sure the swaged end of the
support tube is pointing downward as you secure the ISS (or other sensor
array).
The ISS comes with U-bolts, washers, and hex nuts for the purpose of mounting it on a pole. Consult your ISS Installation Manual for detailed instructions.
Remember, when mounting both sides together, that whichever side of the
ISS is mounted first, the U-bolt from the opposite side ALSO must be placed
around the pole before you tighten anything. (If it is not, there is no way to
slide it in later.)
1/4" Hex Nut
1/4" Lock Washer
Backing Plate
1/4" Flat Washer
1/4" Lock Washe
1/4" Hex Nut
U-Bolts
Rain Collector Side's Mounting Base
Anemometer's Mounting Base
If you wish to put the anemometer higher than the rain collector side of your
ISS on the support tube, follow the instructions in the ISS Installation Manual
for mounting each side separately.
The anemometer arm must point northward or you will have to re-orient the
wind vane after mounting. (As shown in Appendix C in the ISS manual.)
Page 2 Mounting Pole Kit
Loading...