DaVinci JennyLind Changer, 0302 Assembly And Operation Manual

Changer (0302) - Assembly and Operation Manual

Congratulations on purchasing an MDB Family product.
to the following guidelines for assembly, maintenance and operation. This product is for residential use only.
Any institutional use is strictly prohibited.

Please be sure to follow the instructions for proper assembly. Use a Phillips head screwdriver for the assembling the
product. Do not use power screwdrivers. All of our products are made from natural woods. Please understand that
natural woods have color variations which are the result of nature and are not defects in workmanship.

DO NOT SUBSTITUTE PARTS. ALL MODELS HAVE THE SAME QUANTITY OF PARTS AND HARDWARE.

YOUR MODEL MAY LOOK DIFFERENT FROM THE ONE ILLUSTRATED DUE TO STYLISTIC VARIATIONS.

This product will provide many years of service if you adhere

!

WARNING!

READ ALL INSTRUCTIONS BEFORE USE OF THE CHANGING TABLE, ADD-ON
CHANGING UNIT, OR CONTOURED CHANGING PAD.

revised 16JUL2015

page 1

Unpacked and separated all parts, bolts and screws. All holes for attachment, including the ones for an optional
drawer, have been pre-drilled. No drilling by the customer is necessary. Ask your store or call us for replace­ment of missing part.

Do not substitute parts. All models have the same quantity of parts and hardware. Your model may look differ­ent from the one illustrated due to stylistic variations. We continue to improve our product and may make minor
changes to the design. These changes may not be reflected in the instructions.

PARTS

C. Top back rail

A. Left panel B. Right panel

G. Safety strap

F. Shelf boards (3)

H. Metal cross brace (3)

HARDWARE

D. Top front rail

E. Shelf rails (4)

J. Changing pad

Tools Needed

(not included)

K. 2” Allen head bolts & washers (8)

M. 1-1/2” Allen head bolts & washers (6)

L. Barrel nut (8) N. 5/8” Wood

screws (6)

Phillips

screwdriver

O. Allen wrench

page 2

BARREL NUT - ADDITIONAL INSTRUCTION

Step 1

STEP 1.

All barrel nuts are threaded and come pre-attached to the
bolts. Please ensure you have the correct number of
barrel nuts needed as indicated in the instruction manual
before assembly.

Step 2

Insert the barrel nuts all the way into the holes. Do not
insert at an angle to avoid damaging the threaded area.

Step 3

Please use an
washer straight into the threaded nut until it is tight.

* The bolt may not be able to screw
through the barrel nuts smoothly. It is
suggested to use a flat screwdriver to
stabilize and adjust the direction of the
barrel nut.

Please follow the rest of the instruction steps in the instruction manual to complete the assembly.

Allen wrench

to screw the bolt with the lock

Flat Screwdriver

Allen wrench

page 3