
IMPOR TANT: Read the Instructions in this list before reading the attached book or before starting to assemble
the Reverse to the Garden Tractor.
SUPPLEMENT INSTRUCTIONS
FOR
REVERSE ATT ACHMENT MODEL 917.575101
FOR
GARDEN TRACTOR MODEL 917.57599 ONLY
Disregard the model number (917.57589) and heading listed on the cover of the attached book, and instead
always use model number 917.575101. We suggest that you write this model number (917.575101) on the cover
page at once. Also disregard the shipping line-up about the middle of page 2. Use the following information:
1 Bundle Number 575x129 Control Rod
1 Bundle Number 575x190 Reverse Attachment
SETTING UP INSTRUCTIONS
Use the information as given on pages 2 and 3, except the shipping line-up as stated above.
Disregard page 4 and Figure E with paragraph number 22.
1. Refer to Figure A, and discard item number 4 (pawl holder) and component parts — spring and pawl.
2. Insert pawl holder assembly found in carton of parts (new style — double pawls — holders are
interchangeable), into wheel hub, rotate and depress pawls to assist in assembly .
Continue to assemble Reverse with Figure F and information following Figure F , bottom page 5, through pages
6, 7, 8 and 9 except to discard the pawl holder (item number 26 of Figure G) and component parts — spring
and pawl. Also, disregard the last sentence on page 8, which must read: Complete assembly of your reverse
attachment by following information under paragraph 2 above and Figure F with information listed below
Figure F .
PARTS LIST
Figure K is correct as is. Correct the parts list on page 11 as follows:
Illustration Number
13
14
18
21
20
Parts Number
1538U
9456M
575PA453A
575PA454A
575PA663
Quantity Req’d
4
4
1
1
1
Compression Spring
Pawl
Idler Arm & Shafts
Idler Sheave
Flanged Bearing & Arm
Description
Add the following parts:
9461M
9984M
The balance of the Parts List on page 11 is correct for your model Reverse. KS.
2
6
Pawl Holder
Spring Retainer Clip