COUNTER-CURRENT SWIMMING
Hurricane Turbo Swim Jet
INSTALLATION INSTRUCTIONS
PACKET NO.1
With a COUNTER-CURRENT SWIMMING device your swimming pool is no longer a simple
man-made lake. It becomes the most appealing place to be, an amusement park, a place to
have fun and become fit.
A COUNTER-CURRENT SWIMMING device transforms your swimming pool into a water
torrent and gives you general and localized hydrotherapeutic massages.
The high-powered pump of the COUNTER-CURRENT SWIMMING device pumps up water from
the pool and pushes the water back into the pool forcefully, together with millions of air bubbles
which optimise your massages.
FIBREGLASS/VINYL
CUT-OUT OF THE PANEL:
Place the pattern on the inside panel taking the 400 mm
linear dimension between the axis XY and the top of the
structure into account.
Caution: Make sure you position axis XY parallel to the
top of the structure.
Mark the 14 mounting bolt holes on the panel and cut out
the pattern according to the points.
Trace the profile on the panel and carry out the cutting
and drilling.
MOUNTING OF PACKAGE 1 ON THE PANEL:
1- Fitting of the 3 self-adhesive Gaskets:
a) Clean the surface and then stick Gasket (4) to the Counter Flange (2).
b) Clean and then stick Gasket (4) to the back of the Jet Body (1).
c) Clean and then stick Gasket (4) to the flat side of the Flange.
2- Mounting of the Protective Shield:
Mount the Protective Shield (5) using the 3 screws M5 which prevent any kind of deformation of
the liner.
3-Mounting of the Jet Body:
Hold the Counter Flange (2) to the outer side of the panel. Place the Jet Body (1) on the other
side of the panel and keep everything in place by using the 2 fixing screws in A and B.
4-Fixing Bracket for Fibreglass/Vinyl Pools:
After having placed the liner, fill the pool to the base of the Jet Body. Place the Bracket opposite
the Jet Body and place the 12 screws (the liner is simply pierced by the screws). Tighten it
enough for the joint to be well fixed into place but avoid using excessive force. If you are
installing package 2 (= front) immediately, cut the liner with a cutter, otherwise leave in tact.
CONCRETE
DRILLING:
Position the pattern on the inside casing taking
the 400 mm linear dimension between the axis
XY and the top of the structure into account.
CAUTION: Make sure you position axis XY
parallel to the top of the structure.
Pierce the 2 mounting bolt holes of 6 mm
diameter in A and B.
MOUNTING OF PACKAGE 1 ON THE JET BODY:
1. Placing of the self-adhesive Gasket:
Clean the pre-drilled side of the Counter Flange (2) then stick Gasket (4) to Counter Flange.
2. Mounting of the Jet Body:
Place the Counter Flange (2) at the rear of the Jet Body (1) and fix the whole device to the
inside casing by using the 2 fixation screws A and B.
Make sure the outer casing is fixed to the sleeves so that the concrete cannot enter. If this is not
the case, use a piece of polystyrene to fill the gap.
CAUTION: Fix the air intake pipe against the wall of the premises, above water level, by using
the hook provided for said purpose.
Loading...