Datum Systems VoidMate Installation Manual

Base Plate

Foot

End Clamp

Sensor

Plug

On / O Switch

Solar Panel

Sensor

Clamp

Shoulder

Gaiter

1. VoidMate Glossary.

24/7 Helpline: 0845 600 2511 [e-mail]

2. Create a small void in the ballast between sleepers and slide

the VoidMate under the rail.

4. Slide clamp over the foot of the rail.

6. Fit sensor loosely to side of VoidMate.

3. Ensure the VoidMate base is flush under the rail.

The bracket should sit on the foot of the rail as shown.

5. Tighten the bolts on the clamp repetitively and alternatively
using the M10 Allen key until secure.

Systems

VoidMate

TRACK VOID MONITOR

CLOUD STORAGE

Call Datum
24/7 Helpline:

0845 600 2511

11. The VoidMate will continuously stream information via

Platform Interactive.

9. Once fitted check sensor is free to move and switch on
the VoidMate.

10. Call Datum 24/7 Helpline to ensure device is connected.
Provide them with the information listed.

Head Oce

Datum House
The Pavilions
Bridge Hall Lane
Bury, Lancashire
United Kingdom
BL9 7NX

[phone]

[e-mail]

www.datummonitoring.com

@TheDATUMGroup

@DatumMonitoring

8. Insert sensor plug and screw in finger tight.7. Position sensor to sit halfway in its travel range, remove or add

ballast as necessary.

CONTACT DETAILS

Removing the VoidMate

1. Switch o the VoidMate.

2. Fully unscrew sensor plug.

3. Loosen sensor clamp and detach

from VoidMate.

4. Loosen and open the end clamp.

5. Remove the Voidmate.

Serial Number

Company Name

Site Location

Alarm Limit

Alarm Recipients