Datum Systems RailtempMate User Manual

Base Plate

End Clamp

Magnetic

Temperature

Sensor

Shoulder

On / O Switch

Solar Panel

1. RailtempMate Glossary.

Systems

2. Create a small void in the ballast between sleepers and
slide the RailtempMate base plate under the rail.

3. Ensure the RailtempMate base is flush under the rail.
The shoulder should sit on the foot of the rail as shown.

4. Slide the end clamp over the foot of the rail.

Railtemp

Mate

CRT MONITOR

5. Tighten the bolts on the end clamp repeatedly
and alternately using the M10 Allen key.

24/7 Customer Support: 0161 765 3447

www.datum-group.com/about-datum-group/customer-support

CLOUD STORAGE

Call Datum 24/7
Customer Support:

0161 765 3447

9. The RailtempMate will continuously
stream information via
Platform Interactive.

8. Call Datum 24/7 Customer Support to ensure device is
connected. Provide them with the information listed.

Head Oce

Datum House
The Pavilions
Bridge Hall Lane
Bury, Lancashire
United Kingdom
BL9 7NX

CONTACT DETAILS

Removing the
RailtempMate

1. Switch o the RailtempMate.

2. Detach magnetic temperature

sensor from the rail and attach
it to the RailtempMate body.

3. Unscrew the bolts
on the end clamp using
the 10mm Allen key.

4. Remove the RailtempMate
from track.

Serial Number

Company Name

Site Location

Alarm Limit

Alarm Recipients

7. Switch the unit on by turning the on/o
switch clockwise so the arrow points to ‘1’.

6. Relocate magnetic temperature sensor from the
RailtempMate and attach to the rail web.

[phone]

[e-mail]

www.datum-group.com

@TheDATUMGroup

@TheDatumGroup

10. Charging the RailtempMate

1. Remove RailtempMate from track.

2. Unscrew the cap at the bottom

of the RailtempMate.

3. Insert charging cable and charge for a

minimum of 4 hours, ideally overnight.

4. Remove charging cable and

ensure cap is screwed finger
tight back onto the unit.

Cap

Charging Cable