DATUM 6502 RF DISTRIBUTION
•RF Input:
Frequency 0.1 to 10 MHz
Level 1 V rms (nominal)
•RF Output (ten):
Frequency 0.1 to 10 MHz
Level 1 V rms (nominal)
Gain 1 (nominal)
Harmonic Distortion < -40 dB
Non-Harmonic signals < -80 dB
Load Impedance 50 Ohms
Isolation >100 dB*
Connectors BNC
*Isolation between channel one to ten >130 dB
•Additive SSB Phase Noise:
(1 Hz Bandwidth)
Offset from carrier
1 Hz -120 dB
10 Hz -135 dB
100 Hz -145 dB
1000 Hz -155 dB
10000 Hz -160 dB
•Power Requirements:
AC Input (+/-15%) 120 or 230 V AC, <10W
DC Input (optional) 22 to 56 V DC, 10W
•Dimensions:
Height 1U (≈1.75 inches)
Width 19 inches
Depth 10 inches
•Environmental:
Operating Temperature 0 to 55°C
Relative Humidity 0 to 95% (non-condensing)
•Weight: <5 lbs.
•Alarm Output:
Summary alarm indicates failure of any output signal.
Each Output & Main Red LED
Non-alarm condition Relay energized (fail safe)
C Form contacts
Alarm O/P Disable Panel switch
Connector 9 pin D-male
View above shows configuration for rear access distribution and each individual distribution
channel’s red LED fault display. Front access is available upon request.
DATUM markets its products and services through a global network of experienced electronic
professionals. For assistance, additional information, or to place an order, please call us.
Datum
34 Tozer Road,
Beverly, MA 01915-5510
Phone: (+1)978.927.8220 Fax: (+1)978.927.4099
USA Toll Free: 1.800.544.0233
Visit our Web sites at www.ftsdatum.com or
www.datum.com for information on other
DATUM locations, products, and services.
Specifications
Your local representative is:
Specifications subject to change without notice.
(Rev. 7/98)