Datron TW-1000A brochure

POWER SOURCES
The TW1000A amplifier operates direct from any 28V negative ground high current power source. Two separate 110/230V, 50/60Hz rack mounted power supplies are
available. The PS500 Is rated at 50A output and will operate the TW1OOOA
TECHNICAL DESCRIPTION
Each of the two TW1 OOOAplug-in modules uses two separate push pull broadband amplifiers and a combiner.
The amplifiers are mounted on each side of the module on massive heat- sinks. A fan is mounted on the rear of
the module and is activated by separate thermostats on each heat- sink. The combined output of the two
modules pass through the high perfor-
mance harmonic fiiters and a VSWR bridge which supplies the ALC voltage to control the exciter drive
level.
SITOR ARQ OPERATION
The TW1 OOOAis supplied as standard with high speed antenna relay and
control circuitry for SITOR ARQ
·service.
TECHNICAL SPECIFICATIONS
POWER OUTPUT: 1000W PEP SSB, 1000W AVG FSK, CW DUTY CYCLE: Continuous transmit
FREQUENCY RANGE: 2-30MHz Broadband, (1.6-2MHz at reduced harmonic
specifications)
INTERMODULATION DISTORTION: -30dB typical (dependent on exciter) HARMONICS AND SPURIOUS: -60dB
HARMONIC FILTERS: 2-3MHz, 3-5MHz, 5-8MHz, 8-13MHz, 13-20MHz, 20-30MHz DRIVE LEVEL: Approximately 70-80W
OUTPUT IMPEDANCE: 50n <2:1 VSWR
ALC OUTPUT: Compatible with TWC Transceivers and Exciters. Open collector
transistor with conduction level proportional to output. Selectable for peak or average output.
POWER REQUIREMENTS: SSB 28V, 40A AVG
FSK 28V, 60-80A AVG CIRCUIT BREAKER: 100A Magnetic WEIGHT: 52 Ibs. (23.6 kg) SiZE: 8.8" x 19" x 15.4" (22.2 x 48.3 x 38.9 cm) RACK MOUNT: 19"W x 8.75"H (48.3 x 22.2 cm)
Specifications are subject to change without notice.
'M TRANSWORLD COMMUNICATIONS, IN
A SUBSIDIARY OF DATRON SYSTEMS, INC .
.240 Pauma Place, Escondi 92025 USA;
LW 11/87
Loading...