Dateq Dymand User Manual

DYMAND

GEBRUIKSAANWIJZING

USER MANUAL

GEBRAUCHSANWEISUNG

MODE D’EMPLOI

1

Dateq DNA-Dymand Manual Safety instructions

EN

Safety instructions

1 All safety instructions, warnings and operating instructions must be read first.

2 All warnings on the equipment must be heeded.

3 The operating instructions must be followed.

4 Keep the operating instructions for future reference.

5 The equipment may never be used in the immediate vicinity of water; make sure that water and

damp cannot get into the equipment.

6 The equipment may only be installed or fitted in accordance with the manufacturers

recommendations.

7 The equipment must be installed or fitted such that good ventilation is not obstructed in any

way.

8 The equipment may never be installed in the immediate vicinity of sources of heat, such as

parts of heating units, boilers, and other equipment which generates heat (including amplifiers).

9 Connect the equipment to a power supply of the correct voltage, using only the cables

recommended by the manufacturer, as specified in the operating instructions and/or shown on
the connection side of the equipment.

10 The equipment may only be connected to a legally approved earthed mains power supply.

11 The power cable or power cord must be positioned such that it cannot be walked on in normal

use, and objects which might damage the cable or cord cannot be placed on it or against it.
Special attention must be paid to the point at which the cable is attached to the equipment and
where the cable is connected to the power supply.

12 Ensure that foreign objects and liquids cannot get into the equipment.

13 The equipment must be cleaned using the method recommended by the manufacturer.

14 If the equipment is not being used for a prolonged period, the power cable or power cord

should be disconnected from the power supply.

15 In all cases where there is a risk, following an incident, that the equipment could be unsafe,

such as:

• if the power cable or power cord has been damaged

• if foreign objects or liquids (including water) have entered the equipment

• if the equipment has suffered a fall or the casing has been damaged

• if a change in the performance of the equipment is noticed

it must be checked by appropriately qualified technical staff.

16 The user may not carry out any work on the equipment other than that specified in the

operating instructions.

EN

Introduction Dateq DNA-Dymand Manual

2

Introduction to the Dymand

The Dateq DNA-Dymand is a ‘state-of-the-art’ signal processing device that is extremely versatile
and offers maximum sound quality.

A host of superb features make this unit a unique example of modern, sophisticated sound
processing from Dateq.

• a wide range of settings.

• electronically balanced inputs and outputs (including key-in and side-chain).

• downward expander.

• detection low-cut.

• key-in and side-chain.

• audiolevel and gain-reduction indicators.

• status LEDs on all switches.

• stereo link (expander threshold, threshold, ratio, attack and release).

• road-proof housing.

This unit offers superb sound performance in recording, sound reinforcement, and broadcast
environments. It will satisfy the highest demands of today's engineer.

Product support

For questions about the DNA Dymand, accessories and other products, please contact:

Dateq Audio Technologies B.V.

De Paal 37
1351 JG Almere, The Netherlands

Telephone: [phone]
Fax: [phone]
E-mail: [e-mail]
Internet: www.dateq.nl