Datel Design & Development Wireless Gaming Headset User Manual

XBOX 360

Wireless Gaming Headset™

User Guide

V1.00

Congratulations on your purchase of Datels state-of-the-art Wireless Gaming Headset for
Xbox 360. This headset has been specifically developed for maximum performance and
comfort in the heat of gaming battle.

Wireless Gaming headset is the only third party Xbox 360 headset to offer 100%
compatible communication with the Xbox 360 using the consoles proprietary wireless
technology.

To use the Wireless Gaming Headset you will require an Xbox Live® membership. For
more information about Xbox Live®, please see your Xbox 360 set-up manual.

 Wireless Gaming Headset
 USB Charging Cable
 This User Guide

Player Number Indicator Lights: Used to
communicate the assigned player number
and headset status.

Sync Button: Use to sync with an Xbox 360
and to change the assigned player number.

Volume +/- Buttons: Press (+) to increase and
(-) to decrease the earpiece volume

Function Button: Use to turn the headset
on/off and mute the microphone.

DC Charging Jack: Use to charge the headset
using the USB charge cable (supplied).

Microphone: Noise cancelling microphone
should be positioned slightly to the side of
your mouth.

The Wireless Gaming Headset comes with a built-in Lithium Polymer battery that needs to
be charged before first use.

To do this, plug the USB charging cable (supplied) into any USB port on your Xbox 360 and
the other end into the DC Charging Jack on the Wireless Gaming Headset (you will need to

Charging the Headset

Important Information

Before you can use the Wireless Gaming Headset with your Xbox 360 you will need
to charge the built-in battery, Sync the headset with your Xbox 360, turn the headset
on and associate the headset with a player number. Please use the following
sections for advice on each of these requirements.

The Headset

Carton Contents

Battery Safety

The Wireless Gaming Headset comes with a
built-in Lithium-ion Polymer battery,
improper use of which may result in
explosion. Do not heat, open, puncture or
expose to fire.

Hearing Loss

Prolonged exposure to loud volumes may
result in temporary or permanent damage
to your hearing. Be careful not to set the
volume level too high on your headset.
Always take regular breaks when gaming or
chatting.

Safety Information

Introduction

remove the rubber cover first). To begin the charging your Xbox 360 will need to be
powered on. Whilst charging, the Player Number Indictor Lights will begin to flash
alternating in sequence, when charging is complete all four Player Number Indicator
Lights will remain static.

Fully charging the built-in battery can take up to four hours. While charging, the headset
will not function and it’s perfectly normal for the headset to become slightly warm.

Whilst using the headset either 2 audible beeps will be heard to indicate that
approximately 30 minutes of battery life is remaining or 3 audible beeps will be heard to
indicate that approximately 5 minutes of battery life is remaining.

Hint: Check the battery life any time using your Xbox Guide. A battery status meter is
shown beside the headset symbol located within the upper part of the Xbox Guide.

Before you can use the Wireless Gaming Headset for the first time you will need to sync it
with your Xbox 360.

To do this, ensuring that your console is powered on, press and hold the Function button
on the headset until the Player Number Indicator Lights begin to flash continuously. Next
press the Sync button on the headset so that the Player Number Indicator Lights continue

to flash in alternate sequence. To complete the syncing process, press the ‘Sync’ button
on the front of the console.

After a few seconds the headset and console will be synchronised and a player number
will be assigned to the headset and displayed by the Player Number Indicator Lights. The
headset will automatically be assigned the first available player number.

The headset can be worn on either ear. Rotate
the headset arm over the top of the headset to
change ear as shown.

Adjust the head band by sliding it outwards to
achieve a comfortable fit.

Position the mouthpiece so that it is close to
your mouth without being directly in front of it.
This will allow the mic to pick up your voice
clearly without picking up your breathing.

Turning the Headset On/Off

To turn the headset on, press and hold the Function button for at least one second. The
Player Number Indicator Lights will now briefly flash before one of the lights remains
static to indicate the assigned player number. When turning the headset on the headset

Using the Headset

Wearing the Headset

Important syncing advice

A wired headset takes precedence over a wireless headset. You cannot associate a
wireless headset with a controller which a wired headset is connected. If a wired
headset is connected whilst a wireless headset is already associated to your
controller, the wireless headset will automatically disconnect. Please refer to the

section ‘Player Numbers’ for advice on associating the headset with a different

player number.

Syncing the Headset with your Xbox 360

Important charging precautions

For Safety reasons, and to prevent damage to the headset, please ensure that you
follow these recommendations:

 Please recharge the headset at normal room temperature, do not recharge

the headset in temperatures in excess of 30oC.

 Only use the USB charging cable supplied to charge the headset.