Converts Light Intensity to a Voltage
High Irradiance Responsivity, Typically 137
mV/(W/cm2) at p = 635 nm (TSL250R)
321
Compact 3-Lead Clear Plastic Package
Single Voltage Supply Operation
Low Dark (Offset) Voltage....10mV Max
Low Supply Current......1.1 mA Typical
Wide Supply-Voltage Range.... 2.7 V to 5.5 V
Replacements for TSL250, TSL251, and
TSL252
GND
Description
The TSL250R, TSL251R, and TSL252R are light-to-voltage optical sensors, each combining a photodiode and
a transimpedance amplifier (feedback resistor = 16 MΩ, 8 MΩ, and 2.8 MΩ respectively) on a single monolithic
IC. Output voltage is directly proportional to the light intensity (irradiance) on the photodiode. These devices
have improved amplifier offset-voltage stability and low power consumption and are supplied in a 3-lead clear
plastic sidelooker package with an integral lens
DD
OUTV
Functional Block Diagram
–
+
Terminal Functions
TERMINAL
NAMENO.
GND1Ground (substrate). All voltages are referenced to GND.
OUT3Output voltage
V
DD
2Supply voltage
Voltage
Output
DESCRIPTION
www.taosinc.com
Texas Advanced Optoelectronic Solutions Inc.
800 Jupiter Road, Suite 205 Plano, TX 75074 (972) 673-0759
Copyright 2001, TAOS Inc.
1
Page 2
TSL250R, TSL251R, TSL252R
TEST
VOOut ut voltage
V
E
e
µW/cm
T
coefficient of
E
e
µW/cm
g
E
e
196 µW/cm
Irradiance
DD
y
LIGHTTOVOLTAGE OPTICAL SENSORS
TAOS028A – MAY 2001
Absolute Maximum Ratings over operating free-air temperature range (unless otherwise noted)
Lead temperature 1,6 mm (1/16 inch) from case for 10 seconds 240°C. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
†
Stresses beyond those listed under “absolute maximum ratings” may cause permanent damage to the device. These are stress ratings only , and
functional operation of the device at these or any other conditions beyond those indicated under “recommended operating conditions” is not
implied. Exposure to absolute-maximum-rated conditions for extended periods may affect device reliability.
NOTES: 1. All voltages are with respect to GND.
2. Output may be shorted to supply.
Recommended Operating Conditions
MINNOMMAXUNIT
Supply voltage, V
Operating free-air temperature, T
DD
A
2.75.5V
070°C
Electrical Characteristics at VDD = 5 V , TA = 25°C, λp = 635 nm, RL = 10 kΩ (unless otherwise noted)
(see Notes 3, 4, and 5)
TEST
PARAMETER
VDDark voltageEe = 0041004100410mV
Maximum output
V
OM
voltage
VOOutput voltage
p
emperature
coefficient of
α
vo
output voltage
(VO)
Irradiance
N
e
responsivity
I
Supply current
DD
NOTES: 3. Measurements are made with RL = 10 kΩ between output and ground.
4. Optical measurements are made using small-angle incident radiation from an LED optical source.
5. The input irradiance Ee is supplied by an AlInGaP LED with peak wavelength λp = 635 nm
6. The input irradiance Ee is supplied by a GaAlAs LED with peak wavelength λp = 880 nm
7. Irradiance responsivity is characterized over the range VO = 0.05 to 2.9 V. The best-fit straight line of Output Voltage VO versus
irradiance Ee over this range will typically have a positive extrapolated VO value for Ee = 0.
CONDITIONS
VDD = 4.5 V3.03.33.03.33.03.3V
Ee = 14.6 µW/cm
Ee = 38.5 µW/cm
Ee = 196 µW/cm
Ee = 14.6 µW/cm2,
= 14.6
TA = 0°C to 70°C
Ee = 38.5 µW/cm2,
= 38.5
TA = 0°C to 70°C
Ee = 196 µW/cm2,
=
TA = 0°C to 70°C
λp = 635 nm,
See Notes 5 and 7
λp = 880 nm,
See Notes 6 and 7
Ee = 14.6 µW/cm
Ee = 38.5 µW/cm
Ee = 196 µW/cm
2
2
2
,
,
,
2
2
2
TSL250RTSL251RTSL252R
MINTYPMAXMINTYPMAXMINTYPMAX
1.522.5
1.522.5
1.522.5
1.6mV/°C
0.08%/°C
1.6mV/°C
0.08%/°C
1.6mV/°C
0.08%/°C
1375210.2
127489.4
1.11.7
1.11.7
1.11.7
UNIT
V
mV/(µW/cm2)
mA
†
Copyright 2001, TAOS Inc.
2
www.taosinc.com
Page 3
TSL250R, TSL251R, TSL252R
LIGHTTOVOLTAGE OPTICAL SENSORS
TAOS028A – MAY 2001
Dynamic Characteristics at TA = 25°C (see Figure 1)
The device is supplied in a clear plastic three-lead package. The integrated photodiode active area is typically
1,0 mm2 (0.0016 in2) for TSL250R, 0,5 mm2 (0.00078 in2) for the TSL251R, and 0,26 mm2 (0.0004 in2) for the
TSL252R.
0.072 (1,84)
0.189 (4,80)
0.173 (4,40)
0.165 (4,20)
0.150 (3,80)
0.071 (1,80)
0.110 (2,80)
0.016 (0,40)
0.071 (1,8)
0.189 (4,80)
0.173 (4,40)
0.057 (1,44)
0.032 (0,80)
0.016 (0,40)
R 0.035 (0,90)
0.079 (2,00)
0.039 (1,00)
0.027 (0,70)
0.079 (2,00)
0.026 (0,65)
0.018 (0,45)
0.079 (2,00)
Figure 7. Package Configuration
NOTES: A. All linear dimensions are in inches (millimeters).
B. This drawing is subject to change without notice.
C. All dimensions apply before solder dip.
D. Package body is a clear nonfilled optically transparent material
E. Index of refraction of clear plastic is 1.55.
0.029 (0,75)
0.102 (2,6)
0.630 (16,00)
0.531 (13,50)
0.018 (0,45)
Copyright 2001, TAOS Inc.
6
www.taosinc.com
Page 7
TSL250R, TSL251R, TSL252R
LIGHTTOVOLTAGE OPTICAL SENSORS
TAOS028A – MAY 2001
PRODUCTION DATA — information in this document is current at publication date. Products conform to
specifications in accordance with the terms of Texas Advanced Optoelectronic Solutions, Inc. standard
warranty. Production processing does not necessarily include testing of all parameters.
NOTICE
Texas Advanced Optoelectronic Solutions, Inc. (TAOS) reserves the right to make changes to the products contained in this
document to improve performance or for any other purpose, or to discontinue them without notice. Customers are advised
to contact TAOS to obtain the latest product information before placing orders or designing TAOS products into systems.
TAOS assumes no responsibility for the use of any products or circuits described in this document or customer product
design, conveys no license, either expressed or implied, under any patent or other right, and makes no representation that
the circuits are free of patent infringement. TAOS further makes no claim as to the suitability of its products for any particular
purpose, nor does TAOS assume any liability arising out of the use of any product or circuit, and specifically disclaims any
and all liability, including without limitation consequential or incidental damages.
TEXAS ADVANCED OPTOELECTRONIC SOLUTIONS, INC. PRODUCTS ARE NOT DESIGNED OR INTENDED FOR
USE IN CRITICAL APPLICATIONS IN WHICH THE FAILURE OR MALFUNCTION OF THE TAOS PRODUCT MAY
RESUL T I N PERSONAL INJURY OR DEATH. USE OF T AOS PRODUCTS IN LIFE SUPPOR T SYSTEMS IS EXPRESSLY
UNAUTHORIZED AND ANY SUCH USE BY A CUSTOMER IS COMPLETELY AT THE CUSTOMER’S RISK.
TAOS, the TAOS logo, and Texas Advanced Optoelectronic Solutions are trademarks of Texas Advanced Optoelectronic Solutions
Incorporated.