Page 1
查询TS9000供应商
TS9000/TS9000A
Pin assignment
TS9000
1. Gnd
2. Input
3. Output
TS9000A
1. Input
2. Gnd
3. Output
300mA CMOS Low Dropout Voltage Regulator
Pin assignment
TS9000
1. Gnd
2. Input
3. Output
TS9000A
1. Output
2. Gnd
3. Input
Pin assignment
TS9000
1. Input
2. Output
3. Gnd
TS9000A
1. Gnd
2. Output
3. Input
General Description
The TS9000/TS9000A series is a positive voltage regulator developed utilizing CMOS technology featured low quiescent
current, low dropout voltage and high output voltage accuracy. Built in low on-resistor provides low dropout voltage and
large output current. A 2.2uF or greater can be used as an output capacitor.
The TS9000/TS9000A series are prevented device failure under the worst operation condition with both thermal
shutdown and current fold-back. These series are recommended for configuring portable devices and large current
application, respectively.
This series are offered in 3-pin TO-92, SOT-89 and SOT-23 package.
Features
Dropout voltage typically 0.4V @Io=300mA
Output current up to 300mA
Low quiescent current
Output voltage trimmed before assembly
Internal current limit
Ordering Information
Thermal shutdown protection
Applications
Battery power equipment
Personal communication devices
Home electronic appliances
PC peripherals
CD-ROM
Part No. Operating Temp.
Package
(Ambient)
TS9000xCT TO-92
TS9000xCX SOT-23
TS9000xCY SOT-89
TS9000AxCT TO-92
TS9000AxCX SOT-23
TS9000AxCY
Note: Where x denotes voltage option, available are
K=2.5V, M=2.7V, N=2.8V, P=3.0V,
S=3.3V, U=3.5V, V=3.6V, X=3.8V.
Contact factory for additional voltage options.
-40 ~ +85
o
C
SOT-89
Digital signal camera
Block Diagram
Typical Application Circuit
TS9000/A series 1-4 2003/12 rev. B
Page 2
Absolute Maximum Rating
Input Supply Voltage Vin +7 V
Output Current Io PD / (Vin – Vo) V
Power Dissipation SOT-23
SOT-89
TO-92
Thermal Resistance SOT-23
SOT-89
TO-92
Operating Junction Temperature Range Tj -40 ~ +150
Storage Temperature Range T
P
D
Өja
-65 ~ +150
STG
0.3
0.5
0.65
325
180
160
W
o
C/W
o
o
C
C
Lead Soldering Temperature (260 oC) 10 S
Caution: Stress above the listed absolute rating may cause permanent damage to the device.
Electrical Characteris t ic s
o
Ta = 25
Output Voltage Vin=Vo + 0.3V,
Input Supply Voltage Vo+0.3V -- 7 V
Output Voltage Temperature
Coefficient
Line Regulation Vo+1V ≤ Vin ≤ Vo+2V,
Load Regulation 1mA ≤ IL ≤ 300mA -- 0.2 1.0 %
Dropout Voltage Io=300mA, Vo=Vo-2% -- -- 400 mV
Quiescent Current Vin=5V, Io=0A -- 30 50 uA
Short Circuit Current Vout < 0.4V -- 300 400 mA
Output Noise -- 20 -- uVrms
Power Supply Rejection Ratio At 1KHz -- 55 -- dB
C unless otherwise specified.
Parameter Conditions Min Typ Max Unit
0.985|Vo| 1.015|Vo|
1mA ≤ Io
-- 40 -- ppm/ oC
Io=5mA
≤ 300mA,
-- 0.02 0.1 %
Detail Description
The TS9000/TS9000A series of CMOS regulators contain a P-MOS pass transistor, voltage reference, error amplifier,
over current protection and thermal shutdown.
The TS9000/TS9000A series switches from voltage mode to current mode when the load exceeds the rated output
current. This prevents over stress. The TS9000 also incorporates current fold-back to reduce power dissipation when
the output is short circuit. This feature becomes active when the output drops below 0.8V, and reduces the current flow
by 65%. Full current is restored when the voltage exceeds 0.8V.
The internal P-channel pass transistor receives data from the error amplifier, over current shutdown and thermal
protection circuits. During normal operation, the error amplifier compares the output voltage to a precision reference.
Over current and thermal shutdown circuits become active when the junction temperature exceeds 150
o
C, or the
current exceeds 300mA. During thermal shutdown, the output voltage remains low. Normal operation is restored when
the junction temperature drops below 110
o
C.
TS9000/A series 2-4 2003/12 rev. B
Page 3
H
SOT-89 Mechanical Drawing
A
B
G
E
F
D
I
C
J
DIM
A 4.40 4.60 0.173 0.181
B 1.50 1.7 0.059 0.070
C 2.30 2.60 0.090 0.102
D 0.40 0.52 0.016 0.020
E 1.50 1.50 0.059 0.059
F 3.00 3.00 0.118 0.118
G 0.89 1.20 0.035 0.047
H 4.05 4.25 0.159 0.167
I 1.4 1.6 0.055 0.068
J 0.35 0.44 0.014 0.017
SOT-89 DIMENSION
MILLIMETERS INCHES
MIN MAX MIN MAX
SOT-23 Mechanical Drawing
A
B
E
D
C
F
SOT-23 DIMENSION
MILLIMETERS INCHES
MIN MAX MIN MAX
G
DIM
A 2.88 2.91 0.113 0.115
B 0.39 0.42 0.015 0.017
C 1.78 2.03 0.070 0.080
D 0.51 0.61 0.020 0.024
E 1.50 1.70 0.059 0.067
F 1.04 1.08 0.041 0.043
G 0.07 0.09 0.003 0.004
TS9000/A series 3-4 2003/12 rev. B
Page 4
TO-92 Mechanical Drawing
A
TO-92 DIMENSION
DIM
B
C
E F
A 4.30 4.70 0.169 0.185
B 4.30 4.70 0.169 0.185
C 14.30(typ) 0.563(typ)
D 0.43 0.49 0.017 0.019
E 2.19 2.81 0.086 0.111
F 3.30 3.70 0.130 0.146
G 2.42 2.66 0.095 0.105
H 0.37 0.43 0.015 0.017
MILLIMETERS INCHES
MIN MAX MIN MAX
H
D
G
TS9000/A series 4-4 2003/12 rev. B
Loading...