Datasheet STK4362 Datasheet (SANYO)

Page 1
θ
°
°
°
°
8
Thick Film Hybrid IC
STK4362
AF Power Amplifier
(10W + 10W min, THD = 1.0%)

Features

• Capable of guaranteeing substrate temperature 125 ° C, thereby reducing heat sink.
• Excellent cost performance.

Package Dimensions

unit: mm
4033
[STK4362]
Specifications
Maximum Ratings
Parameter Symbol Conditions Ratings Unit
Maximum supply voltage V Thermal resistance Junction temperature Tj 150 Operating substrate temperature T Storage temperature Tstg Available time for load short-circuit t
at Ta = 25 ° C
max Pin 4 to 7, 12 50 V
CC
j-c One power transistor 5
C
30 to +125
V
= 33V, R
= 8 Ω , P
s
CC
L
= 10W, f = 50Hz 2 s
O
125
C/W
C C C
Recommended Operating Conditions
Parameter Symbol Conditions Ratings Unit
Recommended supply voltage V Load resistance R
CC
L
SANYO Electric Co., Ltd. Semiconductor Business Headquarters
TOKYO OFFICE Tokyo Bldg., 1-10, 1 Chome, Ueno, Taito-ku, TOKYO, 110 JAPAN
at Ta = 25 ° C
33 V
61297HA (ID) / 8058MO / 2043KI, TS No. 1229—1/6
Page 2
STK4362
Operating Characteristics
at Ta = 25 ° C, V
= 33V, R
CC
= 8 Ω , Rg = 600 Ω , VG = 40dB, at specified Test Circuit
L
(based on Sample Application Circuit).
Parameter Symbol Conditions min typ max Unit
Quiescent current I
Output power
Total harmonic distortion THD Po = 0.1W, f = 1kHz 0.3 % Frequency response f Input impedance r
Output noise voltage V
Notes. Unless otherwise specified for the power supply at the time of test, use the
constant voltage power supply. When testing the available time for load short-circuit and output noise volt­age, use the specified transformer as shown right. The output noise voltage is the peak value on the mean value indicating rms reading (VTVM), and should not involve impulse noise.
CCO
P
(1) THD = 1.0%, f = 1kHz 10 W
O
P
(2)
O
, f
L
H
i
NO
V
= 38V 20 60 120 mA
CC
THD = 1.0%, f = 30Hz to 20kHz
Po = 0.1W, dB 20 to 100k Hz Po = 0.1W, f = 1kHz 120k
V
+0
3
= 38V, Rg = 10k Ω
CC
5W
0.8 mVrms
Specified Transformer Power Supply
(Equivalent to RP-22)
Equivalent Circuit
No. 1229—2/6
Page 3
STK4362
Sample Application Circuit:
10W min 2-channel AF power amplifier
- W
O
Output power, P
- W
O
Output power, P
Total harmonic distortion, THD - %
Input voltage, Vi - mV Output power, P
Response - dB
- W
O
Frequency, f - Hz Frequency, f - Hz
No. 1229—3/6
Page 4
Response - dBOutput power, P
STK4362
- kQuiescent current, I
i
Input resistance, r
- W
O
- mVrms
NO
Frequency, f - Hz
Supply voltage, V
CC
- V
- mA
- A
CC
CCO
Quiescent current, Icco - mACurrent drain, I
- mVrms
NO
Frequency, f - Hz
Supply voltage, V
CC
- V
- V
N
Quiescent current, Icco - mANeutral voltage, V
Output noise voltage, V
Power supply ripple voltage, Vrp - mVrms
Output noise voltage, V
Signal source resistance, Rg - Ω
No. 1229—4/6
Page 5
STK4362
- V
N
Midpoint voltage, V
IC Power dissipation, Pd - WThermal resistance heat sink, θ - °C/W
Operating substrate temperature, Tc - ° C
- mA
CCO
Quiescent current, Icco - mAQuiescent current, I
Load Short current, Ishort - ACurrent drain, I
- A0.2V / div
CC
Supply voltage, V
CC
- V
Output power, P
O
- W
Area of heat sink, S - cm
Frequency, f - Hz
2
0.5s / div
No. 1229—5/6
Page 6
STK4362
1V / div
0.5s / div
No products described or contained herein are intended for use in surgical implants, life-support systems, aerospace equipment, nuclear
power control systems, vehicles, disaster/crime-pre v ention equipment and the lik e, the failure of which may directly or indirectly cause injury, death or property loss.
Anyone purchasing any products described or contained herein for an above-mentioned use shall:
Accept full responsibility and indemnify and defend SANYO ELECTRIC CO., LTD., its affiliates, subsidiaries and distributors and all their officers and employees, jointly and severally, against any and all claims and litigation and all damages, cost and expenses associated with such use:
Not impose any responsibility for any fault or negligence which may be cited in any such claim or litigation on SANYO ELECTRIC CO., LTD., its affiliates, subsidiaries and distributors or any of their officers and employees, jointly or severally.
Information (including circuit diagrams and circuit parameters) herein is for e xample only; it is not guaranteed for volume production. SANYO believes information herein is accurate and reliable, but no guarantees are made or implied regarding its use or any infringements of intellectual property rights or other rights of third parties.
This catalog provides information as of June, 1997. Specifications and information herein are subject to change without notice.
No. 1229—6/6
Loading...