
DC-DC Switching Regulator
SR16-12W Series
www.powersolve.co.uk
16A SIP & SMT Packages
Non-Isolated
Features
• Non-Isolated POL Converter
• SIP / SMT Packages
• Output Current 16A
• Input Voltage Range 6 - 14VDC
• Output Voltage Range 0.7525 - 5VDC
• Efficiency to 94%
• Over Temperature Protection, Remote On/Off Control
• Continuous Short Circuit Protection
• Output Voltage Sequencing, Power Good Signal
Electrical Specification
INPUT
Input Voltage Range 6.0 - 14V (12V nominal)
Under Voltage Lock-out 5.0V typ. (Power Up)
Input Filter Capacitive
Remote On/Off Control Open Circuit or equal to Vin (Module On)
OUTPUT
Voltage Accuracy ±1.5% max.
Transient Response: 25% step load change <200µ sec.
Ripple and Noise (20MHz BW) [3] 30mV rms, 75mV pk-pk max.
Temperature Coefficient ±0.03% / °C
Short Circuit Protection Continuous
Line Regulation [1] ±0.2%
Load Regulation [2] ±0.5%
Capacitive Load, Low ESR 8000µF max.
External Trim Adj. Range Vo = 0.75 - 5.0VDC
Sequencing Slew Rate Capability (dVseq/dt) 0.1 - 1.0V / m sec.
Sequencing Delay Time 10m sec.
Tracking Accuracy 200mV max. (Power Up)
Power Good Signal Asserted Logic High Vo = 90% - 100% Vo nom.
GENERAL
Efficiency See Table
Isolation Voltage Non-Isolated
Switching Frequency 300KHz typ.
Over Temperature Protection 130°C typ.
Operating Temperature Range -40°C to +85°C
Power Derating See derating curves
Storage Temperature Range -55°C to +125°C
Dimensions 50.8 x 12.95 x 8.30 mm (2.00 x 0.51 x 0.327 Inches) (SIP Package)
Case Non-potted open frame type
Weight 8.5g
NOTE:
1. Measured from High Line to Low Line (Vo set to 3.3VDC).
2. Measured from Full Load to No Load (Vo set to 3.3VDC).
3. Output noise & ripple is measured with a 10µF tantalum & 1µF ceramic capacitor across the output.
4. It is recommended to put a 100µF capacitor with ESR<100mΩ across the input to reduce the input ripple voltage.
5. Suffix ‘N’ to model number for Negative Logic Remote On/Off Control.
6. Suffix ‘P’ to model number for Power Good function.
Typical at nominal line, full load & 25°C unless otherwise stated.
6.5 - 14V (5.0V out version)
4.0V typ. (Power Down)
<0.4VDC (Module Off)
400mV max.(Power Down)
33.0 x 13.46 x 8.8 mm (1.30 x 0.53 x 0.346 Inches) (SMT Package)
Powersolve Electronics Ltd. 8A Arnhem Road, Newbury, RG14 5RU. England
Tel: 01635 521858 Fax: 01635 523771 Email: sales@powersolve.co.uk

DC-DC Switching Regulator
www.powersolve.co.uk
Output Voltage and Current Ratings
MODEL INPUT OUTPUT OUTPUT INPUT CURRENT % EFF.
SR16-12W-05TH 6.0 - 14VDC 1.2VDC 16A 40mA 1882mA 85%
(SIP Package) 6.0 - 14VDC 1.5VDC 16A 50mA 2273mA 88%
SR16-12W-05SM 6.0 - 14VDC 2.5VDC 16A 65mA 3663mA 91%
(SMT Package) 6.0 - 14VDC 3.3VDC 16A 75mA 4731mA 93%
Nominal Input Voltage 12VDC.
VOLTAGE VOLTAGE CURRENT No Load Full Load
6.0 - 14VDC 0.7525VDC 16A 40mA 1250mA 80%
6.0 - 14VDC 1.8VDC 16A 60mA 2697mA 89%
6.0 - 14VDC 2.0VDC 16A 60mA 2963mA 90%
6.5 - 14VDC 5.0VDC 16A 95mA 7092mA 94%
External Resistor Values for
Programming Output Voltage
Vo set (V) Rtrim (KΩ)
0.7525 Open
1.2 22.46
1.5 13.05
1.8 9.024
2.0 7.417
2.5 5.009
3.3 3.122
5.0 1.472
Simplified Schematic
Mechanical and Connection Details
SIP Packages
SR16-12W-05SM (Vo = 3.3V) Derating CurveSR16-12W-05TH (Vo = 3.3V) Derating Curve
All Dimensions in Inches (mm).
Tolerance: Inches x.xx ±0.02 x.xxx ±0.010
Millimeters x.x ±0.5 x.xx ±0.25
SMT Packages
BOTTOM VIEW OF BOARD
Pin Function
1 +Vout
2 +Vout
3 +Sense
4 +Vout
5 Common
6 No Pin/P Good
7 Common
8 +Vin
9 +Vin
10 Sequence
11 Trim
12 On/Off Control
Powersolve Electronics Ltd. 8A Arnhem Road, Newbury, RG14 5RU. England
Tel: 01635 521858 Fax: 01635 523771 Email: sales@powersolve.co.uk