Datasheet SMD0705 Datasheet (Wing Shing)

CRYSTAL UNIT

SMD0705

1. SCOPE

This specification shall cover the characteristics of crystal unit with

SMD0705-10.00—27.00MHz

2. ELECTRICAL SPECIFICATION

ITEM SPECIFICATION
HOLDER TYPE SMD0705
NOMINAL FREQUENCY 10.00—27.00MHz
LOAD CAPACITANCE 10PF to series
OSCILLATION MODE Fundamental

FREQUENCY TOLERANCE AT 25℃±2℃±30PPM
EQUIVALENT SERIES RESISTANCE

DRIVE LEVEL 0.5MW
OPERATING TEMPERATURE RANGE

FREQUENCY STABILITY
SHUNT CAPACITANCE <7PF

AGING
INSULATION RESISTANCE

40Ω max.

-10℃~+60℃

±30PPM

±5PPM/YEAR
>500MΩ at DC 100V

3

.

Dimension (mm)

Wing Shing Computer Components Co., (H.K.)Ltd. Tel:[phone] Fax:[phone]
Homepage: http://www.wingshing.com E-mail: [e-mail]

4. MECHANI

CRYSTAL UNIT

SMD0705

1) Terminal Strength

* Lead pulling test
Conditions: Load 907.2 gram
Direction To the downward
Duration of applied force 5 seconds
Results: There should be no distortion in appearance.

* Lead bending test
Conditions: Load 453.6 gram
Bending angle 90°to normal position
Rate of bending 3 seconds in each cycle
Number of bending 3
Results: There should be no distortion in appearance.

2) Lead solderability test

Conditions: Dipping in solder(+230℃±5℃)for 5 seconds
Results: More than 95% of surface being tested should be
coated uniformly with solder.

CAL SPECIFICATION

3) Vibration test

Conditions: Frequency 10 – 55Hz
Amplitude 0.762mm
Sweep 1.0 minute
Duration 2 hours
Results: Frequency and wave form of tested products must
Remain within specifications.

4) Drop test

Conditions: Method of drop Natural drop
Dropping floor Hard wood board
Height 30cm
Number of drops 3 times
Results: Frequency and wave form of tested products must

remain within specifications.

5. ENVIRONMENTAL SPECIFICATION

CRYSTAL UNIT

SMD0705

1) Temperature test

* Temperature cycling test
Conditions: Steps of cycle 1) At -55℃,30 minutes

2) At +25℃,10 - 15 minutes

3) At +85℃,30 minutes

4) At +25℃,10 - 15 minutes
Number of cycles 3 times
Results: Frequency and wave form of tested products must
remain within specifications.

* Low Temperature test

Conditions: Temperature -20℃±2℃

Length of test 96 hours
Results: There should be no stain on surface of products.
Frequency and wave form of tested products must
remain within specifications.

2) Aging test
Conditions: Temperature +85℃±20℃

Length of test 96 hours

Results: Deviation of frequency must be less than ±3ppm

3) Salt spray test

Conditions: Temperature +35℃±2℃

Length of test 48 hours
NaCI % 5%
Results: There should be no stain on surface of products.

Relative humidity 90 - 95%
Length of test 96 hours
Results: a. Insulation resistance must be 500 MΩ/100 Vac. minimum
b. Resistance and wave form must remain within specifications.

4) Humidity test
Conditions: Temperature +40℃±2℃