Datasheet MVS4100, MVS4200 Datasheet (Perkinelmer)

.

MVS-4100, 4200

Machine Vision Strobe

Description

The PerkinElmer Optoelectronics
MVS 4100 and MVS 4200 are cost­effective strobes for a wide variety of
industrial inspection applications. The
linear xenon flashlamp, mounted in a
reflector for maximum intensity, pro­vides 6 microsecond pulses at flash
rates up to 100 Hz. The energy-per­flash remains constant at 180 mJ; no
range-switching is needed.

These 20 Watt strobes are housed in a
convection-cooled, rugged enclosure.
Threaded hoses at the bottom of the
enclosure allow the unit to be hard
mounted.

The MVS 4100 has an optically iso­lated trigger input and requires an
external +5V TTL pulse to flash. The
MVS 4200 has an internal oscillator
and can be run in either external or
internal trigger mode. The MVS 4200
is ideal as a stand-alone unit for
“stroboscopic” applications.

www.perkinelmer.com/opto

DATASHEET

Lighting

Imaging

Telecom

Machine Vision Illumination Systems

Features

•

Low cost

•

Compact/light weight

•

Universal AC input (90–230 VAC,
560/60 Hz)

•

Long life xenon flashlamp

•

Flash rates to 100 Hz

•

Pulse duration 6 µsec

•

Internal/external trigger

•

Convection cooled

Input voltage
Input current
Flashlamp voltage
Discharge capacitor
Discharge energy
Discharge power
Tirgger input: (1)

Trigger
Pulse duration

Internal oscillator

90 - 230 ±10% VAC, 50/60 Hz

2.0 amps maximum
600 volts

1.0 microfarad ± 10%

0.18 Joules (± 10%)
20 watts maximum

10 - 100 Hz (10 turn potentiometer) (MVS-4200 only)

For more information e-mail us at [e-mail] or visit our web site at www.perkinelmer.com/opto.

All values are nominal; specifications subject to change without notice.

© 2001 PerkinElmer inc. All rights reserved. 0601

.

USA:
PerkinElmer Optoelectronics
35 Congress Street
Salem, MA 01970
Toll Free: [phone] (USA)
Phone: [phone]
Fax: [phone]

Europe:
PerkinElmer Optoelectronics

Wenzel-Jaksch-Str. 31, D-65199
Weisbaden, Germany
Phone: [phone]
Fax: [phone]

Asia:
PerkinElmer Optoelectronics
47 Ayer Rajah Crescent #06-12
Singapore 139947
Phone: [phone]
Fax: [phone]

Spectral bandwidth (1)
Flash rate
Flashlamp life (3)
Flash duration (2)
Flash to flash variation

300 to 1100+ nm
Up to 100 Hz (6,000 fpm)
>10

8

flashes
6 microseconds
< 5%

Optical Specifications

Electrical Specifications

MVS-4100, 4200

www.perkinelmer.com/opto

100-240VAC

2A

MAX

50-60HZ

POWER

EXTERNAL

TRIGGER

INT

8.25 (209.6)

0.50 (12.7)

1/4-20 X .27(6.9) DEEP

MOUNTING HOLES

3 PLACES

2.43 (61.7)

0.56 (14.2)

0.56 (14.2)

2.51

(63.8)

1.88

(47.6)

1.50

(38.1)

6.75 (171.5)

REAR VIEW

AC INPUT

ON-OFF SWITCH

9 PIN CONNECTOR

4.88 (124.0)

EXT

INT

TRIGGER

INTERNAL

FLASH

RATE

Note 1: Spectral bandwidth may be extended into the ultraviolet with other flashlamp envelope and enclosure window materials. Contact factory for IR or UV filters.
Note 2: Measured at 1/3 peak value.
Note 3: Prior to light output decreasing to 50% of the initial value.
Note 4: Area where energy is not less than 50% of maximum.
Note 5: Lux-sec = Lumen-sec/m

2

.

Note 6: Delay between flash command and light output is 8 µsec typical.

+5 volt pulse into opto-isolator with 150 ohm nominal series resistor
10 to 100 microseconds

Distance

6 inches
1 foot
2 feet
3 feet

Area Illuminated

6 in. x 8 in.
12 in. x 16 in.
20 in. x 23 in.
36 in. x 48 in.

Photometric

19 lux-sec

5.7 lux-sec

1.5 lux-sec

0.6 lux-sec

Radiometric

15 x 10

-6

J/cm

2

4.5 x 10-6J/cm

2

1.2 x 10-6J/cm

2

0.5 x 10-6J/cm

2

Illumination Characteristics

Physical Specifications