Accessory Kit
Safety Information
Warning
To prevent possible electrical shock, fire, or personal injury:
• Read all safety information before you use the Product.
• Use the Product only as specified, or the protection
supplied by the Product can be compromised.
• Carefully read all instructions.
• Comply with local and national safety codes. Use personal
protective equipment (approved rubber gloves, face
protection, and flame-resistant clothes) to prevent shock
and arc blast injury where hazardous live conductors are
exposed.
• Use Product-approved measurement category (CAT),
voltage, and amperage rated accessories (probes, test
leads, and adapters) for all measurements.
• Do not touch voltages >30 V ac rms, 42 V ac peak, or
60 V dc.
• Do not use the Product around explosive gas, vapor, or in
damp or wet environments.
• Do not exceed the Measurement Category (CAT) rating of
the lowest rated individual component of a Product,
probe, or accessory.
• Do not use test leads if they are damaged. Examine the
test leads for damaged insulation, exposed metal, or if the
wear indicator (if present) shows. Check test lead
continuity.
• Keep fingers behind the finger guards on the probes.
• Do not use in CAT III or CAT IV environments without the
protective cap (if included with the Product) installed on
test probe. The protective cap decreases the exposed
probe metal to <4 mm. This decreases the possibility of
arc flash from short circuits.
PN 2099739 (English)
July 2003, Rev. 3, 8/20
© 2003-2020 Fluke Corporation. All rights reserved.
All product names are trademarks of their respective companies.
Explanation of Symbols
Consult user documentation.
Double Insulated
WARNING. RISK OF DANGER.
WARNING. HAZARDOUS VOLTAGE. Risk
Measurement Category II is applicable to
Measurement Category III is applicable to
Measurement Category IV is applicable to
Conforms to European Union directives.
of electric shock.
test and measuring circuits connected
directly to utilization points (socket outlets
and similar points) of the low-voltage
MAINS installation.
test and measuring circuits connected to the
distribution part of the building’s low-voltage
MAINS installation.
test and measuring circuits connected at the
source of the building’s low-voltage MAINS
installation.
�
Maintenance
Clean with a soft towel moistened with water and mild
detergent. DO NOT IMMERSE in liquid.
Electrical Specifications
Refer to markings on probe assembly and accessories for
voltage and current specifications. If no CAT rating is marked,
by default ratings are 30 V rms, 42 V ac pk or 60 V dc, 8 A.
Probe tips with >19 mm (0.75 in) exposed metal are rated
30 V ac, 60 V dc, ≤8 A.
Standards and Environmental
Specifications
Temperature .............. -20 °C to 50 °C
Humidity ..................... 0 % to 95 % from 0 °C to 35 °C
Altitude ....................... 2000 m
Safety .......................... IEC 61010-031, Pollution Degree 2
How to Contact Fluke
Fluke Corporation
U.S.A.
Fluke Europe B.V.
The Netherlands
Fluke Corporation operates worldwide. For more contact
information, go to our website: www.fluke.com.
To register your product, view, print, or download the latest
manual or manual supplement, go to our website.
P.O. Box 9090
Everett, WA 98206-9090
+1-425-446-5500
fluke-info@fluke.com
P.O. Box 1186
5602 B.D. Eindhoven
Loading...