
Dual 1 of 4 High Voltage Analog Switch
Ordering Information
Package Options
V
PP-VNN
200V HV20720PJ HV20720X
28-Lead Plastic Die
Chip Carrier
HV20720
Features
❏ HVCMOS® technology for high performance
❏ Operating voltage of up 200V
❏ Very low quiescent current-10µA
❏ Low parasitic capacitances
❏ Over 20MHz bandwidth
❏ -58dB typical output off isolation at 5MHz
❏ 5.0V CMOS logic circuitry
❏ Excellent noise immunity
❏ Flexible high voltage supplies
Absolute Maximum Ratings*
VDD Logic power supply voltage -0.5V to +7.5V
VPP - VNN Supply voltage +220V
VPP Positive high voltage supply -0.5V to +200V
VNN Negative high voltage supply +0.5V to -200V
Logic input voltages -0.5V to VDD +0.3V
V
Analog Signal Range VNN to V
SIG
Peak analog signal current/channel 3.0A
Storage temperature -65°C to +150°C
Power dissipation, 28 pin PLCC 1.2W
PP
General Description
The Supertex HV207 is an 8-channel high-voltage analog switch
integrated circuit (IC) configured as a dual 1 of 4 analog switch.
The 2 sets of 4 analog switches are controlled independently
with the 2 independent 1:4 decoders. The addressed switches
are turned ON and the unaddressed switches are turned OFF. A
logic high on the input clear pin will turn OFF all output switches
regardless of the address input states.
* All voltages are referenced to ground. Absolute maximum ratings are those values
which damage to the device may occur. Functional operation under these
conditions is not implied. Continuous operation of the device at the absolute rating
level may affect device reliability.
11/12/01
Supertex Inc. does not recommend the use of its products in life support applications and will not knowingly sell its products for use in such applications unless it receives an adequate "products liability
indemnification insurance agreement." Supertex does not assume responsibility for use of devices described and limits its liability to the replacement of devices determined to be defective due to
workmanship. No responsibility is assumed for possible omissions or inaccuracies. Circuitry and specifications are subject to change without notice. For the latest product specifications, refer to the
Supertex website: http://www.supertex.com. For complete liability information on all Supertex products, refer to the most current databook or to the Legal/Disclaimer page on the Supertex website.
1

Electrical Characteristics
DC Characteristics (V
Characteristics Sym min typ max Units Test Conditions
Small Signal Switch (ON) Resistance R
Small Signal Switch (ON)Resistance ∆R
Matching
Voltage Drop Across SW at ∆V
Large Positive V
Voltage Drop Across SW at ∆V
Large Negative V
Switch Off Leakage Per Switch I
DC Offset Switch OFF 100 300 mV R
DC Offset Switch ON 100 500 mV R
Pos. HV Supply Current I
Neg. HV Supply Current I
Pos. HV Supply Current I
Neg. HV Supply Current I
Switch Output Peak Current 3.0 2.0 A V
Output Switch Frequency f
I
Supply Current I
PP
Supply Current I
I
NN
Logic Supply Quiescent Current I
SIG
SIG
= + 100V, VNN = -100V, VDD = + 5.0V, TA = + 25°C)
PP
ONS
ONS
SW
SW
SOL
PPQ
NNQ
PPQ
NNQ
SW
PP
NN
DDQ
22 27 Ω V
5.0 20 % V
15 V V
8.0 V V
1.0 10 µAV
10 50 µA All SWs OFF
-10 -50 µA All SWs OFF
10 50 µA All SWs ON, ISW = 5 mA
-10 -50 µA All SWs ON, ISW = 5 mA
50 Khz Duty Cycle = 50%
3.5 5.0 mA 4 SWs turning ON and OFF at 50KHz.
-3.5 -5 mA
10 µA
= 0V, ISW = 5mA
SIG
= 0V, ISW = 5mA
SIG
= +90V, RL = 200Ω
SIG
= -90V, RL = 200Ω
SIG
= Vpp - 10V and VNN + 10V
SIG
=100KΩ
L
=100KΩ
L
duty cycle ≤0.1%
SIG
HV20720
Electrical Characteristics
AC Characteristics (V
Characteristics Sym min typ max Units Test Conditions
Turn On Time t
Turn Off Time t
Maximum V
Off Isolation KO -45 -58 dB f = 5.0MHz, R
Switch Crosstalk K
Output Switch Isolation I
Diode Current duty cycle
Slew Rate dv/dt 13 V/ns
SIG
= + 100V, VNN = - 100V, VDD = + 5.0V, TA = + 25°C)
PP
ON
OFF
CR
ID
-60 dB f = 5.0MHz, R
5.0 µsV
5.0 µsV
300 mA 300ns pulse width, 2.0%
= VPP - 10V, R
SIG
= VPP - 10V, R
SIG
LOAD
LOAD
LOAD
LOAD
= 50Ω
= 50Ω
= 10KΩ
= 10KΩ
2

Operating Conditions
Symbol Parameter Value
V
PP - VNN
V
PP
V
NN
V
DD
V
IH
V
IL
V
SIG
T
A
Notes:
1 Power up/down sequence is arbitrary except GND must be powered-up first and powered-down last.
2V
must be VNN ≤ V
SIG
≤ VPP or floating during power up/down transistion.
SIG
Maximum differential voltage +200V
Positive high voltage supply
Negative high voltage supply
Logic power supply voltage
1
1
1
High-level input voltage VDD -1.5V to V
Low-level input voltage 0V to 1.5V
Analog signal voltage peak-to-peak
2
Operating free air-temperature 0°C to 70°C
+40V to V
NN
+ 200V
-40V to -160V
+4.75V to +5.25V
DD
VNN +10V to VPP -10V
HV20720
Truth Table
A1 A0 CLA B1 B0 CLB SW0A SW1A SW2A SW3A SW0B SW1B SW2B SW3B
L L L L L L ON OFF OFF OFF ON OFF OFF OFF
L H L L H L OFF ON OFF OFF OFF ON OFF OFF
H L L H L L OFF OFF ON OFF OFF OFF ON OFF
H H L H H L OFF OFF OFF ON OFF OFF OFF ON
X X H X X H OFF OFF OFF OFF OFF OFF OFF OFF
Logic Timing Waveforms
A0,A1
CLA
V
DD
50%
50%
0V
V
DD
0V
T
OFF
T
ON
SW0A
SW3A
ON
OFF
ON
OFF
10%
90%
3

Block Diagram
V
CLA
CLB
DD
A0
A1
B0
B1
1:4
Decoder
A
GND
V
DD
1:4
Decoder
B
V
pp
High
Voltage
Level
Trans.
High
Voltage
Level
Trans.
HV20720
SW0A
SW0A
SW1A
SW1A
SW2A
SW2A
SW3A
SW3A
SW0B
SW0B
SW1B
SW1B
SW2B
SW2B
SW3B
SW3B
GND
Pin Configuration
HV207 28-Pin J-Lead
Pin Function Pin Function
1SW3A 15B1
2SW2A 16A0
3SW2A 17A1
4 SW1A 18 CLB
5 SW1A 19 CLA
6 SW0A 20 SW0B
7 SW0A 21 SW0B
8 N/C 22 SW1B
9V
PP
10 N/C 24 SW2B
11 V
NN
12 GND 26 SW3B
13 V
DD
14 B0 28 SW3A
23 SW1B
25 SW2B
27 SW3B
V
NN
Package Outline
24 23 22 21 20
25
26
27
28
1
2
3
4
5
678910
top view
28-pin J-Lead Package
19
18
17
16
15
14
13
12
11
©2001 Supertex Inc. All rights reserved. Unauthorized use or reproduction prohibited.
11/12/01
1235 Bordeaux Drive, Sunnyvale, CA 94089
TEL: (408) 744-0100 • FAX: (408) 222-4895
5
www.supertex.com