Page 1
(888) IPD-CONVerters
●
(888) 473-2668
HAD SERIES - DUAL OUTPUT, 30 WATT
●
www.ipdconverters.com
DESCRIPTION
HAD dual output DC/DC converters feature high
efficiency, open-frame packaging, and 1500 VDC
isolation. The HAD family allows board designers
to deliver any combination of power from
either output, up to each model’s maximum rating.
The HAD uses planar magnetics and has an MTBF of
over a million hours.
TECHNICAL SPECIFICA TIONS
Input
Voltage Range
24 VDC / 48 VDC Nominal 18 - 36 / 34 - 75 VDC
Reflected Ripple 60 mA
Input Reverse Voltage Protection Shunt Diode
Input Transient Withstand 100 V/100 ms
UVLO 24V Input / 48V Input 17V on, 15V off / 33V on, 30V off
Inrush Current Limit 1A2/S
Output
Setpoint Accuracy ±1 %
Line Regulation Vin Min. - Vin Max., I
Load Regulation I
Minimum Output Current, 5V/3.3V 300 mA/500 mA
Dynamic Regulation, Loadstep 25% I
Pk Deviation 4% V
Settling Time 500 µs
Voltage Trim Range ±10%
Power Limit Threshold Range, % of I
OVP Trip Range 115 - 140% V
OVP Type Hiccup
Overcurrent Protection Type Continuous
Min. - I
out
out
Rated 1.0% V
out
Max., Vin Nom. 1.0% V
Rated 110 - 140%
out
Nom.
out
FEATURES
• Independent Dual 5V and
3.3V Outputs
• Flexible Load Sharing
• High Efficiency Topology
• Open-Frame Design
Efficiency vs. Load (48V Input)
out
out
out
out
80
75
70
65
60
55
EFFICIENCY %
50
45
40
10 20 30 40 50 60 70 80 90 100
• Trim And Enable Pins
• Fixed Frequency
• 1500V Isolation
• Planar Magnetics
HAD030ZGE-A
LOAD %
General
Turn-On Time 10 ms
Remote Shutdown
Switching Frequency 500 kHz
Isolation
Input - Output 1500 VDC
Input - Case 1050 VDC
Output - Case 500 VDC
Temperature Coefficient 0.03%/°C
Case Temperature
Operating Range -40 To +100°C
Storage Range -40 To +125°C
Thermal Shutdown Range 105 To 115°C
Humidity Max., Non-Condensing 95%
Vibration, 3 Axes, 5 Min Each 5 g
MTBF† (Bellcore TR-NWT-000332) 1.3 x 106 hrs
Safety Consult Factory
Weight (approx.) 2.4 oz
1
Positive Logic
C-76
Notes
1
For negative logic, add suffix “N” to model number.
†
MTBF predictions may vary slightly from model to model.
Specifications typically at 25°C, normal line, and full load, unless otherwise
stated.
Soldering Conditions: I/O pins, 260°C, ten seconds; fully compatible with
commercial wave-soldering equipment.
Safety: Agency approvals may vary from model to model. Please consult factory
for specific model information.
Units are water-washable and fully compatible with commercial spray or
immersion post wave-solder washing equipment.
Page 2
HAD SERIES - DUAL OUTPUT, 30 WATT
MODELS - (See the last page of this file for options.)
Vin
(Volts)
24
48
Vin Range
(Volts)
18 - 36
34 - 75
Iin Max.*
(Amps)
2.24
1.15
Vout
(Volts)
5.0/ 3.3
5.0/ 3.3
Iout Rated
(Amps)
6.0/ 7.5
6.0/ 7.5
Denotes advanced product release. Consult factory for product availability.
* Max imum input current at mi nimum i nput vo ltag e, maximum rated output power.
** At no minal Vin, rated output.
Note: Current can be drawn from either output to its maximum value, or from both outputs to a combined total of 30 Watts.
MECHANICAL DRAWING
"
2.28
MOUNTING INSERTS
M3X.5 THROUGH 4PL
1.700"(43.2mm)
1.400"(35.6mm)
1.000"(25.4mm)
0.400"(10.2mm)
-0.300"(-7.6mm)
-0.50"(-12.7mm)
0
-0.19"
(-4.8mm)
1
2
3
4
0
(57.9mm)
BOTTOM VIEW
5
6
7
8
9
10
1.900"
(48.3mm)
1.500"(38.1mm)
1.200"(30.5mm)
0.900"(22.9mm)
0.500"(12.7mm)
0.200"(5.1mm)
-0.100"(-2.5mm)
Ripple & Noise
Pk-Pk (mV)
75/7 5
75/7 5
"
2.40
(61.0mm)
DIA 0.040"
(1.0mm)
.025" REF.
(0.6mm)
Effici ency
Typ. **
78%
80%
0.18"
(4.6mm)
0.50"
(12.7mm)
Model
HAD030T GE-A
HAD030ZGE -A
Thermal Impedance
Natural Convection 8.0 °C/W
100 LFM 6.8 °C/W
200 LFM 4.9 °C/W
300 LFM 3.6 °C/W
400 LFM 3.0 °C/W
Note:
Thermal impedance data is dependent on
many environmental factors. The exact
thermal performance should be validated for
specific application.
Pin Function
1-V
in
2 Case
3On/Off
4+V
5 +3.3V
in
out
6 3.3V RETURN
7 3.3V Trim
8 +5V
out
9 5V RETURN
10 5V Trim
C-77
Tolerances
Inches: (Millimeters)
.XX ± 0.020 .X ± 0.5
.XXX ± 0.010 .XX ± 0.25
Pin:
± 0.002 ± 0.05
(Dimensions as listed unless otherwise
specified.)
Page 3
OPTIONS
When ordering equipment options, use the following suffix information. Select the option(s) that
you prefer and add them to the model number. Example ordering options are located below the
options table.
OPTION SUFFIX APPLICABLE SERIES REMARKS
Negative Logic N HAS, HBD, HBS, HES, LES, QBS,
Lucent Compatible Trim T HAS, HBD, HBS, HES, QBS, QES
Terminal Strip TS XWS, XWD, XWT
Trim 1 IAS, LES
Enable 2 I A D, IAS, LES, SMS
Trim and Enable 3 I AS, LES
Current Share 4 S MS
Headerless Y Encapsulated EWS, IWS, OWS
PIN LENGTH AND HEATSINK
OPTIONS
0.110” (2.8mm) Pin Length 8 All Units (Except SMS)
0.150” (3.8mm) Pin Length 9 All Units (Except SMS)
0.24” (6.1mm) Horizontal Heatsink 1H All Units (Except DIP, SIP, and SM
0.24” (6.1mm) Vertical Heatsink 1V All Units (Except DIP, SIP, and SM
0.45” (11.4mm) Horizontal
Heatsink
0.45” (11.4mm) Vertical Heatsink 2V All Units (Except DIP, SIP, and SM
0.95” (24.1mm) Horizontal
Heatsink
0.95” (24.1mm) Vertical Heatsink 3V All Units (Except DIP, SIP, and SM
2H All Units (Except DIP, SIP, and SM
3H All Units (Except DIP, SIP, and SM
QES, TES, TQD
Packages)
Packages)
Packages)
Packages)
Packages)
Packages)
TTL “Low” Turns Module ON
TTL “High” Turns Module OFF
Standard Pin Length is 0.180”
(4.6mm)
Includes Thermal Pad
Includes Thermal Pad
Includes Thermal Pad
Includes Thermal Pad
Includes Thermal Pad
Includes Thermal Pad
Example Options:HBS050ZG-ANT3V = HBS050ZG-A with negative logic, Lucent compatible trim, and
0.95” vertical heatsink.
LES015YJ-3N = LES015YJ with optional trim and enable, negative logic.
QBS066ZG-AT8 = QBS066ZG-A with Lucent compatible trim and 0.110” pin length.
NUCLEAR AND MEDICAL APPLICATIONS Power-One products are not authorized for use as critical components in life support systems,
equipment used in hazardous environments, or nuclear control systems without the express written consent of the President of Power-One, Inc.
TECHNICAL REVISIONS The appearance of products, including safety agency certifications pictured on labels, may change depending on the
date manufactured. Specifications are subject to change without notice.
C105
Loading...