Page 1
PL INTRODUCTION 0 - 1
INTRODUCTION
CONTENTS
page page
GENERAL INFORMATION
E-MARK LABEL ......................... 2
GENERAL INFORMATION
VEHICLE IDENTIFICATION NUMBER
The Vehicle Identification Number (VIN) can be
viewed through the windshield at the upper left corner of the instrument panel next to the left A-pillar
on left-hand-drive vehicles (Fig. 1) and through the
windshield at the upper right corner of the instrument panel next to the right A-pillar on right-handdrive vehicles (Fig. 2). The VIN consists of 17
characters in a combination of letters and numbers
that provide specific information about the vehicle.
Refer to the VIN Decoding Information Table to
interpret VIN code.
MANUFACTURER PLATE .................. 2
VEHICLE IDENTIFICATION NUMBER ......... 1
Fig. 2 VIN Plate Location — RHD
VIN CHECK DIGIT
To protect the consumer from theft and possible
fraud the manufacturer is required to include a check
Digit at the ninth position of the VIN. The check
digit is used by the manufacturer and government
agencies to verify the authenticity of the vehicle and
official documentation. The formula to use the check
digit is not released to the general public.
Fig. 1 VIN Plate Location — LHD
Page 2
0 - 2 INTRODUCTION PL
GENERAL INFORMATION (Continued)
VIN DECODING INFORMATION
POSITION INTERPRETATION CODE = DESCRIPTION
1 Country of origin 1 = United States
3 = Mexico
2 Make C = Chrysler
3 Vehicle Type 3 = Passenger Car
4 Passenger Safety E = Active Restraints, Driver and Passenger Airbags
5 Car Line S = Neon
6 Series M = DD5 5-Speed Manual Transmission
A = 3-Speed Automatic Transmission
7 Body Style 7 = 4 Door Pillared Hardtop
8 Engine C = 2.0L 4 Cyl. 16V SOHC
A = 1.8L 4 Cyl. 16V SOHC
9 Check Digit See explanation in this section.
10 Model Year X = 1999
11 Assembly Plant D = Belvedere Assembly
T = Toluca
12 Thru 17 Build Sequence 6 Digit number assigned by assembly plant
E-MARK LABEL
An E-mark Label (Fig. 3) is located on the rear
shut face of the driver’s door. The label contains the
following information:
• Date of Manufacture
• Month-Day-Hour (MDH)
• Vehicle Identification Number (VIN)
• Country Codes
• Regulation Number
• Regulation Amendment Number
• Approval Number
MANUFACTURER PLATE
The Manufacturer Plate (Fig. 4) is located in the
engine compartment on the right side of the radiator
closure panel crossmember adjacent. The plate contains five lines of information:
1. Vehicle Identification Number (VIN)
2. Gross Vehicle Mass (GVM)
3. Gross Train Mass (GTM)
4. Gross Front Axle Rating (GFAR)
5. Gross Rear Axle Rating (GRAR)
Fig. 4 Manufacturer Plate
Fig. 3 E-Mark Label
Loading...