Datasheet D370-20N, D370-20F, D370-20A, D370-10N, D370-10F Datasheet (AGERE)

...
Page 1
Data Sheet
October 2000
D370-Type Digital Uncooled Laser Module
Applications
Long-reach SONET OC-3/OC-12 systems
SDH STM-1/STM-4 systems
Telecommunications
Secure digital data systems
Features
Eight-pin package suitable for SONET/SDH appli­cations
MQW F-P 1.3 µ m laser with single-mode fiber pig­tail
Wide operating temperature range: –40 ° C to +85 ° C
No TEC required
High output power: typically 1.0 mW peak power coupled into single-mode fiber; 0.2 mW and
2.0 mW versions available
Hermetically sealed active components
Benefits
Easily board mounted
Requires no lead bending
No additional heat sinks required
Pin compatible with industry-standard, 14-pin laser module
Description
The D370-type uncooled laser module consists of a laser diode coupled to a single-mode fiber pigtail. The device is available in a standard, 8-pin configu­ration (see Figure 1 and/or Table 1) and is ideal for long-haul (SONET) and other digital applications.
The module includes a multiquantum-well Fabry­Perot (MQW F-P) laser and an InGaAs PIN photo­diode back-facet monitor in an epoxy-free, hermeti­cally sealed package.
Internal back-facet monitor
Qualification program: TA-983
*
Telcordia Technologies
Technologies, Inc.
is a registered trademark of Telcordia
Telcordia Technologies
*
Page 2
±
°
°
Data Sheet
D370-Type Digital Uncooled Laser Module October 2000
Description
(continued)
The device characteristics listed in this document are met at 1.0 mW output power. Higher- or lower-power operation is possible. Under conditions of a fixed pho­todiode current, the change in optical output is typically
0.5 dB over an operating temperature range of –40 ° C
to +85 ° C. This device incorporates the new laser 2000 manufac-
turing process from the Optoelectronic Products unit of Agere Systems Inc. Laser 2000 is a low-cost platform that targets high-volume manufacturing and tight prod­uct distributions on all optical subassemblies. This plat­form incorporates an advanced optical design that is produced on Agere Systems’ highly automated produc­tion lines. The laser 2000 platform is qualified for the
43 12
56 87
central office and uncontrolled environments, and can be used for applications requiring high performance and low cost.
Table 1. Pin Descriptions
Pin Number Connection
1 NC/reserved 2 Case ground 3 NC/reserved 4 Photodiode cathode 5 Photodiode anode 6 Laser diode cathode 7 Laser diode anode 8 NC/reserved
1-900
Figure 1. D370-Type Digital Uncooled Laser Module Schematic, Top View
Absolute Maximum Ratings
Stresses in excess of the absolute maximum ratings can cause permanent damage to the device. These are abso­lute stress ratings only. Functional operation of the device is not implied at these or any other conditions in excess of those given in the operations sections of the data sheet. Exposure to absolute maximum ratings for extended periods can adversely affect device reliability.
Parameter Symbol Min Max Unit
P
I
MAX
V V
OP
FD
RL RD
C
stg
— —
— —
150
10
2
20
mA
mW
V V
—2mA –40 85 –40 85
C C
Maximum Peak Laser Drive Current or
Maximum Fiber Power
*
Peak Reverse Laser Voltage:
Laser
Monitor Monitor Forward Current I Operating Case Temperature Range T Storage Case Temperature Range T Lead Soldering Temperature/Time 260/10 ° C/s Relative Humidity (noncondensing) RH 85 %
* Rating varies with temperature.
22
Agere Sysems Inc.
Page 3
°
∆λ
±
µ
µ
Data Sheet October 2000 D370-Type Digital Uncooled Laser Module
Handling Precautions
Caution: This device is susceptible to dama ge as a result of electrostatic disc harge (ESD). T ake pr oper pre-
cautions during both handling and testing. Follow guidelines such as JEDEC Pub lication No. 108­A (Dec. 1988).
Although protection circuitry is designed into the device, take proper precautions to avoid exposure to ESD.
Electrical/Optical Characteristics
Table 2. Electrical/Optical Characteristics (over operating temperature range unless otherwise noted)
Parameter Symbol Test Conditions Min Typ Max Unit
Operating Temperature
Range Optical Output Power* P Threshold Current I
Modulation Current I
Slope Efficiency
Center Wav elength RMS Spectral Width Tracking Error TE I Spontaneous Emission P Rise/Fall Times t Forward Voltage V Input Impedance R 3 8 Monitor Current I Monitor Dark Current I Wavelength Temperature
Coefficient
* Higher and lower powers available. See Table 4 for more information. † The slope efficiency is used to calculate the modulation current for a desired output power. This modulation current plus the threshold current
comprise the total operating current for the device.
‡V
R
= reverse voltage.
T –40 85
F
TH
MOD
CW, P
CW, nominal 1 mW
T = 25 ° C
T = full range
= 1.0 mW, T = 25 ° C
F
CW, I
= constant
MON
4.5 1
10
8
9
— 15
15 45
20 35
C
mA mA
mA mA
T = full range
SE CW, P
C
λ
TH
R
F
, t
F
MON
D
F
= 1.0 mW, T = 25 ° C 50 75 100 µ W/mA
F
P
= 1.0 mW, CW 1270 1350 nm
F
P
= 1.0 mW, 155 Mbits/s 2 3 nm
MON
= constant, CW 0.5
TH
I = I
x 0.9 50
1dB
W
10%—90% pulse, T = 25 ° C 0.25 0.5 ns
CW 1.1 1.6 V
R
V
= 5 V 150 750
R
V
= 5 V 10 200 nA
A
0.4 0.5 nm/ ° C
Agere Sysems Inc.
3
Page 4
Data Sheet
D370-Type Digital Uncooled Laser Module October 2000
Characteristic Curve
3.0
L/I CURVE
2.0
FORWARD LASER
1.0
LASER POWER (mW)
MONITOR DIODE CURRENT
0
0 25 50 150
LASER CURRENT (mA)
VOLTAGE
75 100 125
TEMP = 25
o
C
Figure 2. Typical D370-Type Laser Module L/I Curve
2500
2000
1500
1000
500
0
CURRENT (µA)
VOLTAGE (mV)
VOLTAGE (mV)
CURRENT (µA)
1-884
4
Agere Sysems Inc.
Page 5
(
)
Data Sheet October 2000 D370-Type Digital Uncooled Laser Module
Outline Diagram
Dimensions are in inches and (millimeters).
TRADEMARK, CODE, LASER SERIAL NUMBER,
AND/OR DATE CODE IN APPROXIMATE AREA SHOWN
3
4
5678
21
0.52 (13.2)
1.06 (27.0) MIN
39.37 (1000) MIN
PIGTAIL LENGTH
0.20 (5.00)
0.165 (4.20)
0.100 (2.54)
0.300 (7.62)
0.045 (1.143)
0.016 (0.410)
0.110 (2.79)
0.010
(0.254)
0.29
(7.37)
0.17
(4.32)
0.30
7.62
0.085
(2.16)
1-899.f
Agere Sysems Inc.
5
Page 6
Data Sheet
D370-Type Digital Uncooled Laser Module October 2000
Qualification Information
The D370-type laser module has passed the following qualification tests and meets the intent of
ogies
TR-NWT-000468 for interoffice environments and TA-TSY-000983 for outside plant environments.
Table 3. D370-Type Laser Module Qualification Test Plan
Qualification Test Conditions Sample Size Reference
Mechanical Shock
Vibration
Solderability
Thermal Shock
Fiber Pull
Accelerated (Biased) Aging
High-temperature Storage
Temperature Cycling
Cyclic Moisture Resistance
Damp Heat
Internal Moisture
Flammability
ESD Threshold
20 g, 20 Hz—2,000 Hz
40 ° C, 95% RH, 1344 hrs.
<5,000 ppm water vapor
500 G
Delta T = 100 ° C
1 kg; 3 times
85 ° C, 5,000 hrs.
85 ° C, 2,000 hrs.
500 cycles
10 cycles
11 MIL-STD-883
11 MIL-STD-883
11 MIL-STD-883
11 MIL-STD-883
11
25
11
11
11
11 MIL-STD-202
11 MIL-STD-883
TR357
6
Telcordia Technologies
Telcordia Technologies
983, Section 5.18
Telcordia Technologies
Telcordia Technologies
983, Section 5.20
Telcordia Technologies
983, Section 5.23
Section 4.4.2.5
Telcordia Technologies
983, Section 5.22
Telcordia Technol-
Method 2002
Method 2007
Method 2007
Method 2003
983
983
Method 103
Method 1018
6
Agere Sysems Inc.
Page 7
Data Sheet October 2000 D370-Type Digital Uncooled Laser Module
Laser Safety Information
Class IIIb Laser Product
FDA/CDRH Class IIIb laser product. All versions are Class IIIb laser products per CDRH, 21 CFR 1040 Laser Safety requirements. All versions are Class 3B laser products per fied with the FDA under accession number 8720010.
This product complies with 21 CFR 1040.10 and 1040.11.
8.3 µ m single-mode pigtail with optional connector. Wavelength = 1.3 µ
m
Maximum power = 10 mW Because of size constraints, labeling is not affixed to the module but attached to the outside of the shipping carton.
Product is not shipped with power supply.
Caution: Use of controls, adjustments, and procedures other than those specified herein may result in
hazardous laser radiation exposure.
IEC
* 60825-1:1993. The device has been classi-
INVISIBLE LASER RADIATION EMITTED FROM END OF FIBER OR CONNECTOR
Avoid exposure to beam Class 3B Laser Product IEC-60825M 1993 Max. Output: 10 mW Wavelength: 1.3 µm
*
IEC
is a registered trademark of The International Electrotechnical Commission.
DANGER
INVISIBLE LASER RADIATION IS EMITTED FROM THE END OF FIBER OR CONNECTOR Avoid direct exposure to beam
Do not view beam directly with optical instruments
Agere Sysems Inc.
7
Page 8
Data Sheet
D370-Type Digital Uncooled Laser Module October 2000
Ordering Information
Table 4. Ordering Information
Device Code Comcode Pfiber Connector
D370-02A 107950859 0.2 mW SC-PC D370-10A 107950867 1.0 mW SC-PC D370-20A 107950875 2.0 mW SC-PC D370-10B 108096322 1.0 mW SC-APC D370-02F 107950883 0.2 mW FC-PC D370-10F 107950891 1.0 mW FC-PC D370-20F 107950909 2.0 mW FC-PC D370-02N 107950917 0.2 mW none D370-10N 107950925 1.0 mW none D370-20N 107950933 2.0 mW none
For additional information, contact your Agere Systems Account Manager or the following: INTERNET: http://www.agere.com E-MAIL: docmaster@micro.lucent.com N. AMERICA: Agere Systems Inc., 555 Union Boulevard, Room 30L-15P-BA, Allentown, PA 18109-3286
ASIA PACIFIC: Agere Systems Singapore Pte. Ltd., 77 Science Park Drive, #03-18 Cintech III, Singapore 118256 CHINA: Agere Systems (Shanghai) Co., Ltd., 33/F Jin Mao Tower, 88 Century Boulevard Pudong, Shanghai 200121 PRC JAPAN: Agere Systems Japan Ltd., 7-18, Higashi-Gotanda 2-chome, Shinagawa-ku, Tokyo 141, Japan EUROPE: Data Requests: DATALINE: Tel. (44) 7000 582 368, FAX (44) 1189 328 148
Agere Systems Inc. reserves the right to make changes to the product(s) or information contained herein without notice. No liability is assumed as a result of their use or application.
Copyright © 2001 Agere Systems Inc. All Rights Reserved
October 2000 DS99-033LWP-1 (Replaces DS99-033LWP)
1-800-372-2447, FAX 610-712-4106 (In CANADA: 1-800-553-2448, FAX 610-712-4106) Tel. (65) 778 8833, FAX (65) 777 7495 Tel. (86) 21 50471212, FAX (86) 21 50472266 Tel. (81) 3 5421 1600, FAX (81) 3 5421 1700
Technical Inquiries: OPTOELECTRONICS MARKETING: (44) 1344 865 900 (Ascot UK)
Loading...