Datasheet CCA001V1 Datasheet (ST)

Mono class audio amplifier based on TS4962MEIJT in flip chip

Features

■ Operating from Vcc = 2.4 V to 5.5 V

■ Ultra low power consumption in standby mode

(10 nA)

■ 63 dB PSRR @ 217 Hz in grounded mode

(average = 2 V/V)

■ Low pop and click

■ Fast startup time (5 ms)

■ Module gain set at 2 V/V

■ Thermal and short circuit protection

Description

This board is a general-purpose developmant
platform for all applications based on the
TS4962M mono class D audio amplifier. The
TS4962M is a monolithic fully-differential input/
output class D power amplifier. It also includes a
common-mode feedback loop that controls the
output bias value to average it at VCC/2 for any
DC common mode input voltage. This allows the
device to always have a maximum output voltage
swing, and consequently maximizes the output
power. Moreover, as the load is connected
differentially compared to a single-ended topology,
the output is four times higher for the same power
supply voltage.

STEVAL-CCA001V1

Data Brief

STEVAL-CCA001V1

October 2007 Rev 1 1/4

For further information contact your local STMicroelectronics sales office.

www.st.com

4

Board schematic STEVAL-CCA001V1

1 Board schematic

Figure 1. Scheme

Vcc Vcc

Cn1 + J1

1

Cn2

2
3

+

C1

2.2uF/10V

Positive Input

Negative input

GND GND

Cn4 + J2

Stdby

4

C2

100nF

100nF

C3

R1

150k

R2

150k

5

In­In+

1

Cn3 Cn6

Cn5 + J3

-

+

300k

150k

150k

GND

Internal

Bias

PWM

Oscillator

Vcc

38

Vcc

Output

H

Bridge

GND

2

GND

U1

Out+

6

10

Out-

TS4962 Flip-Chip to DIP Adapter

3

Positive Output

Negative Output

2/4

STEVAL-CCA001V1 Revision history

2 Revision history

Table 1. Document revision history

Date Revision Changes

19-Oct-2007 1 Initial release

3/4

STEVAL-CCA001V1

y

Please Read Carefully:

Information in this document is provided solely in connection with ST products. STMicroelectronics NV and its subsidiaries (“ST”) reserve the
right to make changes, corrections, modifications or improvements, to this document, and the products and services described herein at any
time, without notice.

All ST products are sold pursuant to ST’s terms and conditions of sale.

Purchasers are solely responsible for the choice, selection and use of the ST products and services described herein, and ST assumes no
liability whatsoever relating to the choice, selection or use of the ST products and services described herein.

No license, express or implied, by estoppel or otherwise, to any intellectual property rights is granted under this document. If any part of this
document refers to any third party products or services it shall not be deemed a license grant by ST for the use of such third party products
or services, or any intellectual property contained therein or considered as a warranty covering the use in any manner whatsoever of such
third party products or services or any intellectual property contained therein.

UNLESS OTHERWISE SET FORTH IN ST’S TERMS AND CONDITIONS OF SALE ST DISCLAIMS ANY EXPRESS OR IMPLIED
WARRANTY WITH RESPECT TO THE USE AND/OR SALE OF ST PRODUCTS INCLUDING WITHOUT LIMITATION IMPLIED
WARRANTIES OF MERCHANTABILITY, FITNESS FOR A PARTICULAR PURPOSE (AND THEIR EQUIVALENTS UNDER THE LAWS
OF ANY JURISDICTION), OR INFRINGEMENT OF ANY PATENT, COPYRIGHT OR OTHER INTELLECTUAL PROPERTY RIGHT.

UNLESS EXPRESSLY APPROVED IN WRITING BY AN AUTHORIZED ST REPRESENTATIVE, ST PRODUCTS ARE NOT
RECOMMENDED, AUTHORIZED OR WARRANTED FOR USE IN MILITARY, AIR CRAFT, SPACE, LIFE SAVING, OR LIFE SUSTAINING
APPLICATIONS, NOR IN PRODUCTS OR SYSTEMS WHERE FAILURE OR MALFUNCTION MAY RESULT IN PERSONAL INJURY,
DEATH, OR SEVERE PROPERTY OR ENVIRONMENTAL DAMAGE. ST PRODUCTS WHICH ARE NOT SPECIFIED AS "AUTOMOTIVE
GRADE" MAY ONLY BE USED IN AUTOMOTIVE APPLICATIONS AT USER’S OWN RISK.

Resale of ST products with provisions different from the statements and/or technical features set forth in this document shall immediately void
any warranty granted by ST for the ST product or service described herein and shall not create or extend in any manner whatsoever, an
liability of ST.

ST and the ST logo are trademarks or registered trademarks of ST in various countries.

Information in this document supersedes and replaces all information previously supplied.

The ST logo is a registered trademark of STMicroelectronics. All other names are the property of their respective owners.

© 2007 STMicroelectronics - All rights reserved

STMicroelectronics group of companies

Australia - Belgium - Brazil - Canada - China - Czech Republic - Finland - France - Germany - Hong Kong - India - Israel - Italy - Japan -

Malaysia - Malta - Morocco - Singapore - Spain - Sweden - Switzerland - United Kingdom - United States of America

www.st.com

4/4