Datasheet 56 (Β005660), 10 (B001060), 107 (B010770), 106 (ΒΟ10660), 55 (Β005560) Specification

REPLACEMENT BITS FOR ANTEX PRECISION RANGE

Only Antex bits should be used on
Antex soldering irons. They have been

specifi cally designed to match the power
output of the heating elements. Never
apply power to an iron without a bit fi tted.

Antex replacement bits are manufactured
from high grade copper, plated fi rst with

iron and then nickel to give a longer

working life. Never fi le an Antex bit as this
will reduce the working life.

• When replacing an Antex bit, fi rst
switch off the iron, then attach the
new bit.

• Switch on the power and apply solder
to the bit as it heats up for the fi rst
time.

Ref Profi le Tip

ø mm Use On

10 0.5 M, C & TC25

102 2.3 M, C & TC25

103 4.0 M, C & TC25

104 4.7 M, C & TC25

106 1.0 M, C & TC25

107 0.12 M, C & TC25

202 2.3 M, C & TC25

302 2.3 M, C & TC25

820 2.3 M, C & TC25

821 3.0 M, C & TC25

822 4.7 M, C & TC25

• When you have fi nished using the
soldering iron, always place the iron in
a safety stand. (ST4 or ST6A)

• Leave a little residue of solder on the
bit. This will reduce oxidisation of the

tip and ensure a longer bit life.

• Wipe the bit on a clean damp

sponge and apply fresh solder before
re-use.

1100 2.3 CS, TCS & TC50

1101 3.0 CS, TCS & TC50

1102 4.7 CS, TCS & TC50

1103 6.0 CS, TCS & TC50

1105 0.5 CS, TCS & TC50

1106 1.0 CS, TCS & TC50

1107 0.12 CS, TCS & TC50

1108 3.0 CS, TCS & TC50

1109 5.0 CS, TCS & TC50

50 2.3 XS

51 3.0 XS

52 4.7 XS

53 2.3 XS

22

54 3.0 XS

55 0.5 XS

56 1.0 XS

57 0.12 XS

www.antex.co.uk