Page 1
54FCT573
Octal D-Type Latch with TRI-STATE
®
Outputs
General Description
The ’FCT573 is an octal latch with buffered common Latch
Enable (LE) and buffered common Output Enable (OE) inputs.
This device is functionally identical to the ’FCT373 but has
different pinouts.
Features
n Inputs and outputs on opposite sides of package allow
easy interface with microprocessors
n Useful as input or output port for microprocessors
n TTL input and output level compatible
n CMOS power consumption
n Functionally identical to ’FCT373
n TRI-STATE outputs for bus interfacing
n Output sink capability of 32 mA, source capability of
12 mA
n Standard Microcircuit Drawing (SMD) 5962-8863901
Ordering Code
Military Package Package Description
Number
54FCT573DMQB J20A 20-Lead Ceramic Dual-In-Line
54FCT573FMQB W20A 20-Lead Cerpack
54FCT573LMQB E20A 20-Lead Ceramic Leadless Chip Carrier, Type C
Connection Diagram
Pin
Names
Description
D
0–D7
Data Inputs
LE Latch Enable Input (Active HIGH)
OE
TRI-STATE Output Enable Input
(Active LOW)
O
0–O7
TRI-STATE Latch Outputs
TRI-STATE®is a registered trademark of National Semiconductor Corporation.
Pin Assignment
for DIP and Cerpack
DS100951-1
Pin Assignment
for LCC
DS100951-39
August 1998
54FCT573 Octal D-Type Latch with TRI-STATE Outputs
© 1999 National Semiconductor Corporation DS100951 www.national.com
Page 2
Functional Description
The ’FCT573 contains eight D-type latches with TRI-STATE
output buffers. When the Latch Enable (LE) input is HIGH,
data on the D
n
inputs enters the latches. In this condition the
latches are transparent, i.e., a latch output will change state
each time its D input changes. When LE is LOW the latches
store the information that was present on the D inputs a
setup time preceding the HIGH-to-LOW transition of LE. The
TRI-STATE buffers are controlled by the Output Enable (OE)
input. When OE is LOW,the buffers are in the bi-state mode.
When OE is HIGH the buffers are in the high impedance
mode but this does not interfere with entering new data into
the latches.
Function Table
Inputs Outputs
OE
LE D O
LHH H
LHL L
LLX O
0
HXX Z
H
=
HIGH Voltage Level
L=LOW Voltage Level
X=Immaterial
O
0
=
Value stored from previous clock cycle
Logic Diagram
DS100951-3
Please note that this diagram is provided only for the understanding of logic operations and should not be used to estimate propagation delays.
54FCT573
www.national.com 2
Page 3
Absolute Maximum Ratings (Note 1)
If Military/Aerospace specified devices are required,
please contact the National Semiconductor Sales Office/
Distributors for availability and specifications.
Storage Temperature −65˚C to +150˚C
Ambient Temperature under Bias −55˚C to +125˚C
Junction Temperature under Bias
Ceramic −55˚C to +175˚C
V
CC
Pin Potential to
Ground Pin −0.5V to +7.0V
Input Voltage (Note 2) −0.5V to +7.0V
Input Current (Note 2) −30 mA to +5.0 mA
Voltage Applied to Any Output
in the Disabled or
Power-Off State −0.5V to +5.5V
in the HIGH State −0.5V to V
CC
Current Applied to Output
in LOW State (Max) Twice the rated I
OL
(mA)
DC Latchup Source Current −500 mA
Recommended Operating
Conditions
Free Air Ambient Temperature
Military −55˚C to +125˚C
Supply Voltage
Military +4.5V to +5.5V
Minimum Input Edge Rate (∆V/∆t)
Data Input 50 mV/ns
Enable Input 20 mV/ns
Note 1: Absolute maximum ratings are values beyond which the device may
be damaged or have its useful life impaired. Functional operation under these
conditions is not implied.
Note 2: Either voltage limit or current limit is sufficient to protect inputs.
DC Electrical Characteristics
Symbol Parameter FCT573 Units V
CC
Conditions
Min Typ Max
V
IH
Input HIGH Voltage 2.0 V Recognized HIGH Signal
V
IL
Input LOW Voltage 0.8 V Recognized LOW Signal
V
CD
Input Clamp Diode Voltage −1.2 V Min I
IN
=
−18 mA
V
OH
Output HIGH
Voltage
54FCT 4.3
V Min
I
OH
=
−300 µA
54FCT 2.4 I
OH
=
−12 mA
V
OL
Output LOW
Voltage
54FCT 0.2 V Min I
OL
=
300 µA
54FCT 0.5 I
OL
=
32 mA
I
IH
Input HIGH Current 5 µA Max V
IN
=
V
CC
I
IL
Input LOW Current −5 µA Max V
IN
=
0.0V
I
OZH
Output Leakage Current 50 µA 0 −
5.5V
V
OUT
=
2.7V; OE=2.0V
I
OZL
Output Leakage Current −50 µA 0 −
5.5V
V
OUT
=
0.5V; OE=2.0V
I
OS
Output Short-Circuit Current -60 mA Max V
OUT
=
0.0V
I
CCQ
Quiescent Power Supply Current 1.5 mA Max V
IN
<
0.2V or VIN5.3V, VCC=
5.5V
∆I
CC
Quiescent Power
Supply Current
2.0 mA Max V
I
=
3.4V, V
CC
= 5.5V
I
CCD
Dynamic I
CC
0.4 mA/
MHz
Max Outputs Open, VCC= 5.5V, V
IN
5.3V or V
IN
<
0.2V, One Bit
Toggling, 50%Duty Cycle, OE
=
GND, LE=V
CC
I
CC
Total Power Supply
Current
6.0 mA Max Outputs Open, fCP= 10 MHz,
V
CC
= 5.5V, VIN5.3V or V
IN
<
0.2V, One Bit Toggling, 50
%
Duty Cycle, OE=GND, LE
=
V
CC
54FCT573
www.national.com3
Page 4
AC Electrical Characteristics
Symbol Parameter 54FCT Units Fig.
No.
T
A
=
−55˚C to +125˚C
V
CC
=
4.5V to 5.5V
C
L
=
50 pF
Min Max
t
PLH
Propagation Delay 1.0 8.5 ns
Figure 4
t
PHL
Dnto O
n
1.0 8.5
t
PLH
Propagation Delay 1.0 15.0 ns
Figure 4
t
PHL
LE to O
n
1.0 15.0
t
PZH
Output Enable Time 1.0 13.5 ns
Figure 6
t
PZL
1.0 13.5
t
PHZ
Output Disable Time 1.0 10.0 ns
Figure 6
t
PLZ
Time 1.0 10.0
AC Operating Requirements
Symbol Parameter 54FCT Units Fig.
No.
T
A
=
−55˚C to +125˚C
V
CC
=
4.5V to 5.5V
C
L
=
50 pF
Min Max
t
s
(H) Set Time, HIGH 2.0 ns
Figure 7
ts(L) or LOW Dnto LE 2.0
t
h
(H) Hold Time, HIGH 1.5 ns
Figure 7
th(L) or LOW Dnto LE 1.5
t
w
(H) Pulse Width, 6.0 ns
Figure 5
LE HIGH
Capacitance
Symbol Parameter Max Units Conditions
(T
A
=
25˚C)
C
IN
Input Capacitance 10 pF V
CC
=
0V
C
OUT
(Note 3) Output Capacitance 12 pF V
CC
=
5.0V
Note 3: C
OUT
is measured at frequency f=1 MHz per MIL-STD-883B, Method 3012.
54FCT573
www.national.com 4
Page 5
AC Loading
DS100951-4
*Includes jig and probe capacitance
FIGURE 1. Test Load
DS100951-6
FIGURE 2. Test Input Signal Levels
Amplitude Rep. Rate t
w
t
r
t
f
3.0V 1 MHz 500 ns 2.5 ns 2.5 ns
FIGURE 3. Test Input Signal Requirements
DS100951-8
FIGURE 4. Propagation Delay Waveforms for
Inverting and Non-Inverting Functions
DS100951-5
FIGURE 5. Propagation Delay,
Pulse Width Waveforms
DS100951-7
FIGURE 6. TRI-STATE Output HIGH
and LOW Enable and Disable Times
DS100951-9
FIGURE 7. Setup Time, Hold Time
and Recovery Time Waveforms
54FCT573
www.national.com5
Page 6
Physical Dimensions inches (millimeters) unless otherwise noted
20-Lead Ceramic Leadless Chip Carrier
NS Package Number E20A
20-Lead Ceramic Dual-In-Line
NS Package Number J20A
54FCT573
www.national.com 6
Page 7
Physical Dimensions inches (millimeters) unless otherwise noted (Continued)
LIFE SUPPORT POLICY
NATIONAL’S PRODUCTS ARE NOT AUTHORIZED FOR USE AS CRITICAL COMPONENTS IN LIFE SUPPORT
DEVICES OR SYSTEMS WITHOUT THE EXPRESS WRITTEN APPROVAL OF THE PRESIDENT AND GENERAL
COUNSEL OF NATIONAL SEMICONDUCTOR CORPORATION. As used herein:
1. Life support devices or systems are devices or
systems which, (a) are intended for surgical implant
into the body, or (b) support or sustain life, and
whose failure to perform when properly used in
accordance with instructions for use provided in the
labeling, can be reasonably expected to result in a
significant injury to the user.
2. A critical component is any component of a life
support device or system whose failure to perform
can be reasonably expected to cause the failure of
the life support device or system, or to affect its
safety or effectiveness.
National Semiconductor
Corporation
Americas
Tel: 1-800-272-9959
Fax: 1-800-737-7018
Email: support@nsc.com
National Semiconductor
Europe
Fax: +49 (0) 1 80-530 85 86
Email: europe.support@nsc.com
Deutsch Tel: +49 (0) 1 80-530 85 85
English Tel: +49 (0) 1 80-532 78 32
Français Tel: +49 (0) 1 80-532 93 58
Italiano Tel: +49 (0) 1 80-534 16 80
National Semiconductor
Asia Pacific Customer
Response Group
Tel: 65-2544466
Fax: 65-2504466
Email: sea.support@nsc.com
National Semiconductor
Japan Ltd.
Tel: 81-3-5639-7560
Fax: 81-3-5639-7507
www.national.com
20-Lead Ceramic Flatpack
NS Package Number W20A
54FCT573 Octal D-Type Latch with TRI-STATE Outputs
National does not assume any responsibility for use of any circuitry described, no circuit patent licenses are implied and National reserves the right at any time without notice to change said circuitry and specifications.
Loading...