32GB - 288-Pin 2Rx4 Registered ECC DDR4 DIMM
Identification
DVM26R2T4/32G 4Gx72
32GB 2Rx4 PC4-2666V-R-19
Performance Range
Clock / Module Speed / CL-t
RCD
–tRP
1333 Hz / PC4-2666 / 19-19-19
1200 MHz / PC4-2400 / 18-18-18
1200 MHz / PC4-2400 / 17-17-17
1067MHz / PC4-2133 / 16-16-16
1067MHz / PC4-2133 / 15-15-15
933 Hz / PC4-1866 / 14-14-14
933 Hz / PC4-1866 / 13-13-13
800 Hz / PC4-1600 / 12-12-12
667 MHz / PC4-1600 / 10-10-10
288-pin JEDEC-compliant DIMM, 133.35 mm wide by 31.25 mm high
Operating Voltage: VDD/VDDQ = 1.2V (1.14V to 1.26V)
VPP = 2.5V (2.375V to 2.75V)
VDDSPD = 2.25V to 2.75V
I/O Type: 1.2 V signaling
On-board I2C temperature sensor with integrated Serial Presence-Detect (SPD) EEPROM
Data Transfer Rate: 21.3 Gigabytes/sec
Data Bursts: 8 and burst chop 4 mode
ZQ Calibration for Output Driver and On-Die Termination (ODT)
Programmable ODT / Dynamic ODT during Writes
Programmable CAS Latency: 10, 12, 13, 14, 15, 16, 17, 18 and 19
Bi-directional Differential Data Strobe signals
Per DRAM Addressability is supported
Write CRC is supported at all speed grades
DBI (Data Bus Inversion) is supported (x8 only)
CA parity (Command/Address Parity) mode is supported
Supports ECC error correction and detection
16 internal banks
SDRAM Addressing (Row/Col/BG/BA): 17/10/2/2
Fully RoHS Compliant
DVM26R2T4/32G is a registered 4Gx72 memory
module, which conforms to JEDEC's DDR4-2666,
PC4-2666 standard. The assembly is Dual-Rank.
Each rank is comprised of eighteen 2Gbx4 DDR42666 SDRAMs.
One EEPROM is used for Serial Presence Detect
and a combination register/PLL, with Address and
Command Parity, is also used.
Both output driver strength and input termination
impedance are programmable to maintain signal
integrity on the I/O signals in a Fly-by topology.
A thermal sensor accurately monitors the DIMM
module and can prevent exceeding the maximum
operating temperature of 95C.
Tolerances on all dimensions
except where otherwise
indicated are .13 (.005).
All dimensions are expressed
in millimeters [inches]
DVM26R2T4/32G 31-Aug-16
Copyright 2017 Dataram Memory | U.S.A. Headquarters +1 609-799-0071 | Offices in Europe and Asia | www.dataram.com
The information contained in this document has been carefully checked and is believed to be reliable and accurate. However, Dataram assumes no responsibility for errors.