16GB - 288-Pin 2Rx8 Unbuffered ECC DDR4 DIMM
Identification
DVM21E2T8/16G 2Gx72
16GB 2Rx8 PC4-2133P-E-15
Performance Range
Clock / Module Speed / CL-t
RCD
–tRP
1067 MHz / PC4-2133 / 16-16-16
1067 MHz / PC4-2133 / 15-15-15
933 MHz / PC4-1866 / 14-14-14
933 MHz / PC4-1866 / 13-13-13
800 MHz / PC4-1600 / 12-12-12
800 MHz / PC4-1600 / 11-11-11
667 MHz / PC4-1600 / 10-10-10
667 MHz / PC4-1600 / 9-9-9
288-pin JEDEC-compliant DIMM, 133.35 mm wide by 31.25 mm high
Operating Voltage: VDD/VDDQ = 1.2V (1.14V to 1.26V)
VPP = 2.5V (2.375V to 2.75V)
VDDSPD = 2.25V to 2.75V
I/O Type: 1.2 V signaling
On-board I2C temperature sensor with integrated Serial Presence-Detect (SPD) EEPROM
Data Transfer Rate: 17.0 Gigabytes/sec
Data Bursts: 8 and burst chop 4 mode
ZQ Calibration for Output Driver and On-Die Termination (ODT)
Programmable ODT / Dynamic ODT during Writes
Programmable CAS Latency: 9, 10, 11, 12, 13, 14, 15 and 16
Bi-directional Differential Data Strobe signals
Per DRAM Addressability is supported
Write CRC is supported at all speed grades
DBI (Data Bus Inversion) is supported (x8 only)
CA parity (Command/Address Parity) mode is supported
Supports ECC error correction and detection
16 internal banks
SDRAM Addressing (Row/Col/BG/BA): 16/10/2/2
Fully RoHS Compliant
DVM21E2T8/16G is an Unbuffered 2Gx72 memory
module, which conforms to JEDEC's DDR4-2133,
PC4-2133 standard. The assembly is Dual-Rank.
Each rank is comprised of nine 1Gbx8 DDR4-2133
SDRAMs.
One EEPROM is used for Serial Presence Detect
and a combination register/PLL, with Address and
Command Parity, is also used.
Both output driver strength and input termination
impedance are programmable to maintain signal
integrity on the I/O signals in a Fly-by topology.
A thermal sensor accurately monitors the DIMM
module and can prevent exceeding the maximum
operating temperature of 95C.
Tolerances on all dimensions
except where otherwise
indicated are .13 (.005).
All dimensions are expressed
in millimeters [inches]
DVM21E2T8/16G 10-Dec-15
Copyright 2015 Dataram Corporation | U.S.A. Headquarters +1 609-799-0071 | Offices in Europe and Asia | www.dataram.com
The information contained in this document has been carefully checked and is believed to be reliable and accurate. However, Dataram assumes no responsibility for errors.