Dataram DVM16E2S8-8G User Manual

DVM16E2S8/8G

8GB - 240-Pin 2Rx8 Unbuffered ECC DDR3 DIMM

Identification
DVM16E2S8/8G 1Gx72

8GB 2Rx8 PC3-12800E-11

Performance Range
Clock / Module Speed / CL-t

RCD

–tRP
800 MHz / PC3-12800 / 11-11-11
667 MHz / PC3-10600 / 10-10-10
667 MHz / PC3-10600 / 9-9-9
533 MHz / PC3-8500 / 8-8-8
533 MHz / PC3-8500 / 7-7-7
400 MHz / PC3-6400 / 6-6-6

Features

Description

240-pin JEDEC-compliant DIMM, 133.35 mm wide by 30.00 mm high
Operating Voltage: 1.5V +0.075V, I/O Type: SSTL_15
On-board I2C temperature sensor with integrated Serial Presence-Detect (SPD) EEPROM
Data Transfer Rate: 12.8 Gigabytes/sec
Data Bursts: 8 and burst chop 4 mode
ZQ Calibration for Output Driver and On-Die Termination (ODT)
Programmable ODT / Dynamic ODT during Writes
Programmable CAS Latency: 6, 7, 8, 9, 10 and 11
Bi-directional Differential Data Strobe signals
SDRAM Addressing (Row/Col/BG/BA): 16/10/3
Fully RoHS Compliant

DVM16E2S8/8G is an unbuffered 1Gx72 memory
module, which conforms to JEDEC's DDR3, PC3­12800 standard. The assembly is Dual Rank. Each
rank is comprised of nine 512Mx8 DDR3 SDRAMs.

One EEPROM is used for Serial Presence Detect
and a combination register/PLL, with Address and
Command Parity, is also used.

Both output driver strength and input termination
impedance are programmable to maintain signal
integrity on the I/O signals in a Fly-by topology.

A thermal sensor accurately monitors the DIMM
module and can prevent exceeding the maximum
operating temperature of 95C.

Notes

Tolerances on all dimensions
except where otherwise
indicated are .13 (.005).

All dimensions are expressed
in millimeters [inches]

DVM16E2S8/8G 10-Nov-15
Copyright  2015 Dataram Corporation | U.S.A. Headquarters [phone] | Offices in Europe and Asia | www.dataram.com

The information contained in this document has been carefully checked and is believed to be reliable and accurate. However, Dataram assumes no responsibility for errors.