Datamax-O'Neil OC-2-3 SERIES Shoulder Strap User Manual

OC Shoulder Strap

Swivel mount

Slides

(220238-000)

Attaching the Shoulder Strap to an OC
Printer

To attach the shoulder strap to an OC printer, do
the following:

1. Place the printer face down so the swivel
mount, located on the bottom of the printer, is
visible.

2. Place the shoulder strap bracket in the swivel
mount on the OC printer, as shown below.

Adjusting the Length of the Shoulder
Strap

The length of the shoulder strap can easily be
adjusted.

Grasp the slide on the shoulder strap, and then
carefully pull the strip of the shoulder strap in the
desired direction, to make the shoulde r str ap
longer or shorter.

Note: Do not pull the loose end of the shoulder
strap all the way through the slide or it will
become detached. Leave approximately two
inches of slack.

Note: The shoulder strap is designed to be used
only with the OC 2/3 printers.

3. Rotate the shoulder strap bracket until it locks
into place, as shown below.

OC 2/3 Printers

Shoulder Strap

110214-002

Agency Approvals

This page left intentionally blank.

FCC Notice

This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits
are designed to provide reasonable protection against harmful interfer ence
in a residential installation.
This equipment generates, uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, it may
cause harmful interference to radio communications. However there is no
guarantee that interference will not occur in a particular install ation. If this
equipment does cause harmful interference to radio or tele vision reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the
following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and rece iver.

• Connect the equipment to an outlet on a circuit different from that
to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Applicable Directive

• 89/336/EEC, 73/23/EEC

Applicable Standards

• EN55022 (1998)

• EN55024 (1998)

• EN60950 (1992)

Warranty

The Company warrants that Datamax-O’Neil products are free from
defects in manufacturing materials and workmanship for one (1) year from
date of original purchase to Buyer/Distributor (OEMs 90 days from the date
of purchase). Batteries, cables, power supplies, and other accessories will
be warranted for ninety (90) days. Datamax-O’Neil makes no other
warranties, expressed or implied, including implied warranties of
merchantability and fitness of purpose.
If you try to repair, disassemble, or change the product in any way, or use
parts not provided by Datamax-O’Neil without prior, written authorization,
all warranties are void.
For complete warranty and service information, see the Warranty Card
included in your printer's original packaging.

No Liability for Negligent Use

In no event shall Datamax-O’Neil be held liable for any damages
whatsoever (including, without limitations, damages for loss of profits,
business interruption, loss of information, or other pecuniary loss) arising
out of negligence in use and care of the product.

COPYRIGHT © 2010, DATAMAX-O’NEIL