Datamax-O'Neil microFlash 4t-4te IP54 Cases User Manual

Congratulations! You’ve just purchased an accessory
that will allow your rugged Datamax-O’Neil printer to
go the extra mile. Proper use of this case will allow our
MF4Te Series printer to be used in harsh, dusty, or
rainy environments.

This case is certified to be an IP54 rating, so when
properly used, it will protect your product against
particles as small as dust, and water from any
direction.

NOTE: These cases are not compatib l e wit h MF4Te
printers that include the optional magnetic stripe card
reader.

Installation Instructions

1. Remove the case from any protective wrapping and
packaging.

2. Unzip the case to install the printer.

3. Install the printer (Figure 1). Be sure that the
printer’s edges will be encased by the printer case.

NOTE: When the printer is in transport or not in use, it
is necessary to fully secure the paper flaps to allow
maximum protection of the printer.

• The top cover flap can also be velcroed to the top
of the case to allow easier removal of media while
maintaining additional protection to the printer
(Figure 6 and 7). (NOTE: This configuration does

not offer full IP54 protection.)

Figure 3

Options

• The printer can be worn in the IP54 case with a
swivel belt clip or swivel belt loop (Figure 4).

Figure 1

4. Zip the printer flap to secure the pr inter in place
(Figure 2).

Figure 2

5. Close the top cover, then secure all covers with the
hook and loop fasteners provided.

6. The power jack is located under the velcro flap.
Access the port on the right side of the case.

Figure 4

Figure 6

• The printer can be worn with a shoulder strap
(included) (Figure 5).

Figure 7

Figure 5

MF4Te

110239-002

IP54 Cases

Agency Approvals

Applicable Directive

• 89/336/EEC, 73/23/EEC
Applicable Standards

• EN55022 (1998)

• EN55024 (1998)

• EN60950 (1992)

Warranty

The Company warrants that Datamax-O’Neil products are free from
defects in manufacturing material s and workman shi p for one (1 ) year
from date of original purchase to Buyer/Distributor (OEMs 90 days
from the date of purchase). Batteries, cables, power supplies, and
other accessories will be warranted for ninety (90) days. Datamax­O’Neil makes no other warranties, expressed or implied, including
implied warranties of merchantability and fitness of purpose.

If you try to repair, disassemble, or change the product in any way, or
use parts not provided by Datamax-O’Neil without prior, written
authorization, all warranties are void. For complete warranty and
service information, see the Warranty Card included in your printer's
original packaging.

No Liability for Negligent Use

In no event shall Datamax-O’Neil be held liable for any damages
whatsoever (including, without limitati ons, damages for loss of profits,
business interruption, loss of information, or other pecuniary loss)
arising out of negligence in use and care of the product.

COPYRIGHT © 2010, DATAMAX-O'NEIL