Datamax-O'Neil M-Class Mark II Static brush User Manual

92-2457-01 Rev.B

Installation Instructions

1. Turn ‘Off’ and unplug the printer.

2. Open the cover. Using the illustrations below, locate the area where the Static Brush will be installed.

3. Using a Cotton Swab or cloth, moistened with isopropyl alcohol, gently clean the surface where the Static Brush will be installed.

Isopropyl alcohol is a flammable solvent; always take the proper precautions when using this substance.

WARNING

4. Peel the backing from the adhesive strip on the back of the Static Brush and affix the brush to the printer in the location shown in



Note: The Static brus h should be inst alled so the bristles are as c lose to the ribbon wi thout actually touching. It may be nece ssary

M-Class Printers



Note: For M-Class printers, the Static Brush must be cut to length in order to fit properly.

the below illustrations.

to install a roll of ribbon in order to properly align the brush to the ribbon.

Static

Brush

I-Class Printers

Static

Brush

H-Class Printers

Static

Brush