Datalogic STD-P090 User manual

Installation and Utilization

1

2

3

4

5

6

7

8

9

STD-P090

General Features

The STD-P090 is a stand for PowerScan™ 9000 family bar code
readers, for hands-free operation. It also helps to keep the reader's
handle within the operator's reach.

The mounting kit supplied with the stand contains the following

p

onents:

com

•three self-tapping screws

•two adhesive strips

Utilization

Insert the reader into the stand as shown at left. Rotate the holder
as needed to position the reader for the best orientation with
respect to the bar codes.

Assembling the STD-P090

To assemble the STD-P090 proceed as follows, referring to
the figure at right:

1. Connect the left and right supports (1) and
the central support (2) with the positioning screw (3).

2. Push the bridge (6) down onto the supports and wedge
into plac

3. Position the assembly by screwing the central support (2)
into the tube (4).

4.

Position the assembly onto the base by fixing the tube
(4) onto the base wi

e.

th the fixing screw (5).

fix them to

Fixed Desktop Use

The STD-P090 can be mounted to any surface using either the
three self-tapping screws (8) or the two double-sided adhe­sive strips (9); alternatively, the three adhesive bump
be used (7).

Mounting with screws:

1. Be sure that the STD-P090 is already assembled.

2. Affix the STD-P090 base to the desired surface by means
of the th

ree self-tapping screws (8)

Mounting with adhesive strips:

1. Carefully clean the bottom surface of the base with alco­hol to remove any impurities that could reduce the adhesion.

2. Remove the protective plastic from one
surface of the base.

3. Remove the plastic from the other side of the strips and affix

The surface must be smooth and clean to all

©2014 Datalogic, Inc. • All rights reserved. • Datalogic and the
Datalogic logo are registered trademarks of Datalogic S.p.A. in
many countries, including the U.S.A. and the E.U.

www.datalogic.com

ers can

.

side of the adhesive strips (9) and stick them onto the bottom

the STD-P090 to the desired surface.

ow correct adhesion.

820063514 (Rev A) June 2014