Datalogic HLD-P080 User manual

HLD-P080

Mounting
holes

Desk/Wall Holder

Mounting Instructions

The HLD-P080 is a plastic holder for the PowerScan™ 8000 and
PowerScan™ 9000 families of barcode readers, designed to be
mounted on a wall or fixed to a desk.

Installation

The mounting kit supplied with the holder contains the following
components:

•1 HLD-P080

•1 spacer

• 2 self-tapping screws

•2 threaded dowels

• 2 adhesive strips

When used with PowerScan™ 8000 readers without display, the
spacer must be installed to the holder as shown in Figure 1.

Figure 1

Desktop Use

To fix the HLD-P080 to a desktop, use the double-sided adhesive
strips following the steps below:

1. Carefully clean the surfaces of the desk and of the bottom of the HLD-P080 with alcohol to remove any impurities that could reduce the adhesion.

2. Remove the protective plastic from one side of the adhesive strips and stick them on the HLD-P080 bottom as shown in Figure 2.

Figure 2

3. Remove the plastic from the other side of the strips and affix the HLD-P080 to the desk.

Wall-Mount Use

Wall mounting is accomplished using the two threaded dowels and
the self-tapping screws, which will be inserted into the two holder
mounting holes.

Figure 3

.

©2007-2014 Datalogic, Inc. • All rights reserved. Datalogic and the Datalogic logo are regis­tered trademarks of Datalogic S.p.A.in many countries, including the U.S.A. and the E.U.

www.datalogic.com

820057014 (Rev. C) February 2014

1. Using the holder mounting holes as a pattern, mark the wall where you desire to mount the HLD-P080.

2. Drill two appropriate-size holes.

3. Insert the threaded dowels into the holes.

4. Position the holder on the wall with the opening inclined upwards and affix it by means of the two screws.

Figure 4